Western Digital WDG2TP10000N User Manual (pdf) - Page 17
Not Con d, Setting Mismatched
UPC - 718037119137
View all Western Digital WDG2TP10000N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
MY BOOK PRO EDITION II USER MANUAL Condition Messages My Book RAID Manager reports the following condition messages depending on the current status of your drive. Message Healthy Degraded Rebuilding Bad Setting Mismatched Not Configured Unknown Description Your device is "healthy" and operating. Your device is still functioning but the drive in either slot A or B may have a problem. Refer to section 7 of this manual for information on how to replace a drive. Your device is in RAID 1 mode and is rebuilding the data for a newly replaced disk. The rebuilding process may take up to 12 hours depending on the capacity of your drive. Your data in the device is still accessible while it's rebuilding. Your device may have a problem. Disconnect then reconnect the power cable and/or the interface cable. If the problem persists, visit our WD knowledge base at support.wdc.com for more information and help. Your device is in RAID 1 mode with both drives detected as master. You must designate a single master (disk A or B) using RAID Manager. The data on the master will be accessed and mirrored to the secondary drive during the rebuilding process. The RAID setting is not configured. Use RAID Manager to configure it to either RAID 0 or RAID 1. The RAID configuration information is not available. The driver for My Book interface device may not be installed properly. Turn off the device, re-install My Book RAID Manager and/or drivers from the software CD and turn the device back on. Your system should detect My Book and prompt you to install the driver. Allow your system to automatically locate the driver and complete the installation. MY BOOK RAID MANAGER FOR WINDOWS - 14