Whirlpool CAM2752TQ Installation Instructions - Page 5
Checkelectrical, Requirements., Besureyou Have, Correctelectricalsupplyand, Recommendedgrounding, - water level
UPC - 883049046303
View all Whirlpool CAM2752TQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
F bose 112" (1.3 cm) L nut JB 1 U • Use legs and nuts from parts package, Screw nut down to within 1/2 inch (1,3 cm) of base, 11. Insert legs into correct J holes at each front corner of washer until nuts touch washer, Da Not tighten nuts until Step 14, 2 mTilt washer backward and remove corner posts, Gently lower washer to floor, Move washer to its permanent location. Remove cardboard or hardboard from under washer. 1_ raising back legs 1 inch (2,5 cm) off of floor, To adjust rear self-leveling legs, gently lower washer to floor, Check levelness of the washer by placing a carpenter's level on top of the washer, first side to side; then front to back, 5 • Remove the service door of the meter case, Lift the service door up at the back and remove, Install money accepting device (refer to manufacturers instructions for proper installation), For machines using coin slides, use adapter kit (provided with unit), Replace meter case service door, l_)a CHECK ELECTRICAL REQUIREMENTSB.ESUREYOU HAVE CORRECTELECTRICALSUPPLYAND RECOMMENDEDGROUNDING METHOD. 17. Check that all parts are now installed, See parts list, Page 3, If there is an extra part, go back through steps to see which step was skipped, 1 _% mTurn on water faucets and check for leaks, Tighten couplings if there is leaking, Do Not overtighten; this could cause damage to faucets, 1 •For electrolmechnical models only. Check the wash cycle time, The washer has a 9-minute wash in the Normal Cycle, Remove the timer from the meter case of the washer to manually start the timer, Start the washer and allow it to complete the Normal cycle, Rotate counterclockwise timer "off" position Timer-frontview Timers can be started by turning the clutch assembly counterclockwise until the washer starts to fill with water, 2 • If the washer fails to start or does not give the proper washer cycle time, the clutch assembly of the timer can be adjusted, Remove the timer from the meter case, Adjust the clutch assembly screw clockwise if the washer does not start after the coin slide mechanism has been fully actuated in or out, Adjust the clutch assembly counterclockwise if the washer segment of the Normal cycle was less than 9 minutes, 4mlf washer is not level, adjust the front legs up or down, Make final check with level, When washer is level, use wrench to turn nuts on front legs up tightly against washer base. If nuts are not fight against washer base, the washer may vibrate. PAGE 5 tqk m _j! •Check that you have all of your tools, Check that the shipping strap was removed from the back of the washer and used to secure the drain hose, If entire strop is not removed, washer may vibrate and be noisy. 0 • Plug power supply cord into grounded outlet, timer clutch adjuslment screw