Whirlpool GU3100XTVQ Installation Instructions - Page 15

5. Using ⁵⁄₈" or ⁷⁄₈" I.D. hose and a coupler, connect the 2 drain hose ends with hose clamps. B A A A. Hose clamps B. Coupler 6. Connect the drain hose to the air gap, waste tee or disposal with clamps. Attach Dishwasher to Cabinet WARNING Tip Over Hazard Do not use dishwasher until completely installed. Do not push down on open door. Doing so can result in serious injury or cuts. 7. Open the door about 3" (7.6 cm) and check that the space between the inner door and tub is equal on both sides. 8. If spacing is not equal, loosen the bracket screws and shift the tub. Retighten bracket screws. 9. Check that the top of the door does not contact the screws, brackets or countertop. If it does, the dishwasher must be lowered and leveled again. See "Level Dishwasher" in "Install Dishwasher." 10. Remove towel from dishwasher. 11. Reinstall the lower dish rack. Complete Installation 1. Place the lower panel behind the toekick panel. 2. Place the 2 panels against the legs of the dishwasher. 3. Align the slots on the inner panel with the toekick bracket screw holes. The lower panel should be touching the floor. 4. Insert the 4 toekick screws into the top 4 screw holes. 1. Open the dishwasher door and remove the lower dish rack. 2. Place a towel over the pump assembly and spray arm of dishwasher to keep screws from falling into pump area during installation. 3. Check that the dishwasher is level and centered side to side in the opening. 4. Check that the tub flange aligns with the front face of the cabinet frame. 5. Attach the dishwasher to the countertop using the 2 brackets on top of the dishwasher. NOTE: The dishwasher must be attached to the countertop to keep it from tipping when the door is opened. A B A. Top 4 screw holes B. 2-piece toekick A A. Brackets 6. Insert 2 #8 x ⁵⁄₈" Phillips flat-head screws through the brackets and into the countertop. 15