Whirlpool GU3100XTVQ Installation Instructions - Page 9

Install Water Line 1. Drill a ¹⁄₂" (1.3 cm) hole in the left-hand cabinet side, the rear or floor of opening. A B 4. Use a rubber hose connector (not provided) with spring- or screw-type clamps (not provided) to connect the air gap to the waste disposal inlet above the drain trap and at least 20" (50.8 cm) above the floor. A B C D A. Optional locations B. Preferred locations 2. Measure the overall length of the copper tubing required. 3. Attach the copper tubing to the water supply line with a manual shutoff valve. 4. Slowly feed the copper tubing through the hole in the cabinet. NOTE: The copper tubing will bend and kink easily. The copper tubing should be far enough into the cabinet opening to connect it to the dishwasher inlet on the front lefthand side of the dishwasher. 5. Turn on the water shutoff valve. Run water into a shallow pan to flush the copper tubing of particles that may clog the inlet valve. 6. Turn off the shutoff valve. Connect Drain Hose to Air Gap-Waste Disposal IMPORTANT: Always use a new drain hose even when installing a new replacement dishwasher. 1. Drill a 1¹⁄₂" (3.8 cm) diameter hole in the cabinet wall or floor on the side of the opening closest to the sink. - E H GF A. Drain hose-cut here, if needed B. Spring- or screw-type clamps C. Air gap D. Large spring-type clamp E. Drain hose F. Rubber hose connector G. Disposal inlet H. Drain trap 5. Insert the drain hose through the hole cut in the cabinet and to the center front of the opening where the drain connection will be made. A A. Drain hose 2. Remove the waste disposal knockout plug. Cut the end of the drain hose, if needed. NOTE: Do not cut the ribbed section. 3. Attach the drain hose to the air gap with the large spring-type clamp. NOTE: If the drain hose was cut, use 1¹⁄₂" to 2" (3.8 to 5 cm) screw-type clamp (not provided). Connect Drain Hose to Air Gap-No Waste Disposal IMPORTANT: Always use a new drain hose even when installing a new replacement dishwasher. 1. Drill a 1¹⁄₂" (3.8 cm) diameter hole in the cabinet wall or floor on the side of the opening closest to the sink. - 2. Cut the end of the drain hose, if needed. NOTE: Do not cut the ribbed section. 9