Whirlpool WED94HEXW Installation Instructions - Page 12

4. Connect remaining wires 2. Connect neutral ground wire and neutral wire B E C Place hooked ends of remaining direct wire cable wires under outer terminal block screws (hooks facing right). Squeeze hooked ends together and tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to Venting Requirements. Optional External Ground for 3-Wire Connection (Power Supply Cord Shown) IMPORTANT: You must verify with a qualified electrician that this grounding method is acceptable before connecting. 1. Prepare to connect neutral ground wire and neutral wire Connect neutral ground wire (E) and neutral wire (white or center wire) (C) of power supply cord or cable under center, terminal block screw (B). Tighten screw. 3. Connect remaining wires E B Place ends of remaining wires under outer terminal block screws. Tighten screws. A 4. Connect external ground wire Install the correct strain relief for your electrical connection method, as shown on page 8 or 10. Remove center terminal block screw (B). Remove neutral ground wire (E) from green external ground conductor screw (A). A G Connect a separate copper ground wire (G) under the green external ground conductor screw (A) to an adequate ground. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to Venting Requirements. 12