Whirlpool WED94HEXW Installation Instructions - Page 9

3. Connect ground wire 1. Remove center screw A B F Connect ground wire (F) (green or bare) of power supply cord under green external ground conductor screw (A). Tighten screw. 4. Connect remaining wires Remove center terminal block screw (B). 2. Connect neutral wire B C Connect remaining wires under outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to Venting Requirements. Connect neutral wire (white or center) (C) of power supply cord under center terminal block screw (B). Tighten screw. 3. Connect remaining wires 3-Wire Power Supply Cord Connection Use where local codes permit connecting cabinet-ground conductor to neutral wire. 3-wire receptacle (NEMA type 10-30R) 3-prong plug Connect remaining wires under outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to Venting Requirements. Spade terminals with upturned ends Ring terminals 9