Whirlpool WFE775H0HV Owners Manual - Page 15

STORAGE DRAWER (on some models) Check that storage drawer is cool and empty before cleaning. Cleaning Method: ■■ Mild detergent OVEN CAVITY Use AquaLift® Technology regularly to clean oven spills. Do not use oven cleaners. Food spills should be cleaned when oven cools. At high temperatures, foods react with porcelain. Staining, etching, pitting, or faint white spots can result. Cleaning Method: ■■ Clean cycle: See the "Clean Cycle" section. Oven Light The oven light is a standard 40-watt appliance bulb. Before replacing, make sure the oven and cooktop are cool and the control knobs are in the Off position. To Replace: 1. Unplug range or disconnect power. 2. Turn the glass bulb cover in the back of the oven counterclockwise to remove. 3. Turn bulb counterclockwise to remove from socket. 4. Replace bulb, then bulb cover by turning clockwise. 5. Plug in range or reconnect power. TROUBLESHOOTING First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call, refer to the warranty page in these instructions, or visit producthelp.www.whirlpool.com. In Canada, visit www.whirlpool.ca Contact us by mail with any questions or concerns at the address below: In the U.S.A.: Whirlpool Brand Home Appliances Customer eXperience Center 553 Benson Road Benton Harbor, MI 49022-2692 In Canada: Whirlpool Brand Home Appliances Customer eXperience Centre 200 - 6750 Century Ave. Mississauga, Ontario L5N 0B7 Please include a daytime phone number in your correspondence. Problem Possible Causes and/or Solutions Nothing will operate Cooktop will not operate Power supply cord is unplugged: Plug into a grounded outlet. Household fuse is blown or a circuit breaker is tripped: Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician. The control displays an F9 or F9 E0 error code: The electrical outlet in the home may be miswired. Contact a qualified electrician to verify the electrical supply. The control knob is not set correctly: Push in knob before turning to a setting. On ceramic glass models, the oven control lockout is set: See "Control Lock" in the "Feature Guide" section. Excessive heat around cookware on cooktop Cooktop cooking results not what expected Cookware is not the proper size: Use cookware about the same size as the surface cooking area, element, or surface burner. Cookware should not extend more than 1/2" (13 mm) outside the cooking area. Control knob set to incorrect heat level: See the "Cooktop" section. Range is not level: Level the range. See the Installation Instructions. Cooktop element cycles on and off on Hi setting Oven will not operate Oven temperature too high or too low Oven indicator lights flash Display shows messages Element cycling due to a temperature limiter: This is normal operation. The element may cycle on and off to keep the cooktop from overheating. Delay Start is set: See the "Cook Time" section. Control is locked: Press and hold the Start keypad for 3 seconds to unlock. The range is in Demo mode: Demo mode will deactivate all oven elements. See "Demo Mode" in the "Electronic Oven Controls" section. Electronic oven control set incorrectly: See the "Electronic Oven Controls" section. Oven temperature needs adjustment: See "Oven Temperature Control" in the "Electronic Oven Controls" section. Power to range is turned on or restored: See "Control Display" in the "Electronic Oven Controls" section. If the indicator lights keep flashing, call for service. Power failure (display shows flashing time): Clear the display. On some models, reset the clock, if needed. See "Clock" keypad feature in the "Feature Guide" section. Error code (display shows letter followed by number): Depending on your model, press CANCEL to clear the display. See "Control Display" in the "Electronic Oven Controls" section. If it reappears, call for service. 15