Whirlpool WFW9620HBK Owners Manual - Page 10

Using the Dispensers 1. For automatic dispensing, open the bulk dispenser drawer using the handle at the base of the washer. For a single load, open the single-load dispenser drawer at the top left corner of the washer and disable the Load & Go™ option. 2. Add laundry products as described below. 3. Slowly close the dispenser drawer. Make sure it is completely closed. NOTES: ■■ A small amount of water may remain in the single load dispenser from the previous wash cycle. This is normal. ■■ See "About Detergent Concentration" for information on detergent concentration. ■■ When detergent in the bulk dispenser is running low, the display will show the detergent level (Low). ■■ Add single-dose and Oxi-type boosters to the drum before loading items. See the "Using Your Washer" section. Adding HE detergent to dispenser Load & Go™ bulk dispenser Use only High Efficiency (HE) liquid detergents. The bulk dispensers will hold about 67.6 oz (2 L) or 33.8 oz (1 L) of liquid HE detergent, depending on dispenser, or enough for many loads of laundry. To Fill Bulk Dispeners: Adding detergent for a single load Use only High Efficiency (HE) detergent. Selector Open the dispenser drawer by pulling on the handle at the base of the washer. If desired, the bulk dispensers can be completely removed from the drawer. Tab Locate the Load & Go™ bulk dispenser. Gently pull up on the tab located on the bulk dispenser lid to lift the fill door. Fill to the "MAX" line (see illustrations at right) with HE liquid detergent or liquid fabric softener (1-liter dispenser only). Close fill door. It will click into place. Make sure the concentration setting is correct (see the "Choosing the Right Detergent" section). "MAX" line It is recommended that you rinse out the Load & Go™ containers when refilling, when changing detergent types or concentrations, or when the washer will not be used for an extended period. For instructions on cleaning the dispenser cartridge, see the "Washer Care" section. For instructions on changing detergent concentration, see "Using Your Washer, Step 11. HE detergent compartment Use only High Efficiency (HE) detergent. Pour a measured amount of HE detergent into detergent compartment. For powdered detergent, lift the selector to the high position. For liquid detergent, push down the selector to the low position. Do not overfill; adding too much detergent may cause detergent to be dispensed into the washer too early. Powdered detergent: Lift the selector to the high position. Add directly to the compartment. Liquid detergent: Push down the selector to the low position. Add directly to the compartment. IMPORTANT: ■■ Disable Load & Go™ dispenser(s) as desired (see Step 11 in "Using Your Washer"). ■■ Do not add single-dose laundry packet to dispenser drawer. 10