Whirlpool WGT4027EW Installation Guide - Page 13
Remove Shipping Strap 27 models
View all Whirlpool WGT4027EW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Remove Shipping Strap (27" models) 3. Cut shipping strap CUT HERE To avoid floor damage, set washer/dryer onto cardboard before moving across floor. Move washer/dryer close to its final location. 1. Remove strap, hang tag, and pin Cut the shipping strap about 16" (406 mm) from the plug end. Look for the words "CUT HERE." Discard end with cotter pins. You will use the remaining piece of shipping strap to secure the drain hose. Do not cut yellow strap. Pull yellow strap firmly, until completely removed from washer/dryer. There should be 2 cotter pins on the end of the shipping strap. Remove the hang tag and pin from the vent pipe. 2. Check rear leveling legs Tilt the washer/dryer forward. Move each of the 2 rear legs in an up-down motion to check the self-adjusting leveling legs for free movement. This is required for proper leveling. Gently lower the washer/dryer to the floor. 13