Whirlpool WML75011HN Installation Instructions - Page 5
Vent Cover Installation, Locate Wall Studs
View all Whirlpool WML75011HN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
3. Secure damper assembly with 2 sheet metal screws. Note: To ensure good performance of airflow, for Wall and Roof venting, remove the charcoal filter from the bottom plate before operating the microwave oven. 2. Place the vent cover C (removed from step 1) to area A, and rotate 180 degree. Charcoal Filter C B A E Grease Filter Vent Cover Installation (for both upper vent and wall vent installation) 1. Remove screws attaching vent cover B, C and D to top of microwave exterior. Slide out vent covers B, C and D. Keep the vent cover C for step 2 use. A 3. Attach the vent covers located in the upper polyfoam (see item J in "Parts Supplied" section). 4. Attach the vent covers to vents B & C using the screws removed in step 1. A B C D E A. Screws B. Vent Cover C. Vent Cover D. Vent Cover E. Top front of the microwave NOTE: Keep the vent cover B and vent cover D for recirculation in future. B C E A. Screw B. Vent cover (located in upper polyfoam) C. Vent cover (located in upper polyfoam) E. Top front of the microwave Locate Wall Stud(s) NOTE: If no wall studs exist within the cabinet opening, do not install the microwave oven. 1. Using a stud finder, locate the edges of the wall stud(s) within the opening. See illustrations in "Possible Wall Stud Configurations." 2. Mark the center of each stud and draw a plumb line down each stud center. See illustrations in "Possible Wall Stud Configurations." 5