Whirlpool WRF995FIFZ Use & Care Guide - Page 15
Refrigerator Leveling, and Door Closing
View all Whirlpool WRF995FIFZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
3. Firmly push the handle toward the door until the handle base is flush against the door. 4. While holding the handle, insert the short end of the hex key into the upper hole and slightly rotate the hex key until it is engaged in the setscrew. 5. Using a clockwise motion, tighten the setscrew just until it begins to contact the shoulder screw. Do not fully tighten. 6. Repeat steps 4 and 5 to fasten the lower setscrew. 7. Once both setscrews have been partially tightened as instructed in the previous steps, fully tighten both setscrews. IMPORTANT: When the screws feel tight, tighten them an additional quarter turn. The handle is not properly installed without this extra tightening. 8. Repeat steps 2 through 7 to install the other handle onto the adjacent refrigerator door. Freezer Drawer 1. With the drawer closed, place the handle onto the shoulder screws so that the setscrews are facing down toward the floor. A B A. Shoulder screw B. Setscrews inside the handle 2. F irmly push the handle toward the drawer until the handle base is flush against the drawer. 3. Insert the short end of the hex key into the left-hand hole and slightly rotate the hex key until it is engaged in the setscrew. 4. U sing a left-to-right motion, tighten the setscrew a quarter turn at a time just until it begins to contact the shoulder screw. Do not fully tighten. 5. Repeat steps 3 and 4 to fasten the right-hand setscrew to the shoulder screw. 6. Once both setscrews have been partially tightened as instructed in the previous steps, fully tighten both setscrews. IMPORTANT: When the screws feel tight, tighten them an additional quarter turn. The handle is not properly installed without this extra tightening. 7. Save the hex key and all instructions. Remove the Handles 1. While holding the handle, insert the short end of the hex key into a setscrew hole and slightly rotate the hex key until it is engaged in the setscrew. 2. Using a right-to-left motion, loosen the setscrew a quarter turn at a time. 3. Repeat steps 1 and 2 for the other setscrew. Slowly pull the handle away from the door or drawer. 4. If necessary, use a Phillips screwdriver to remove the shoulder screws from the door. Refrigerator Leveling and Door Closing The base grille covers the adjustable brake feet and roller assemblies located at the bottom of the refrigerator below the freezer drawer. Before making any adjustments, remove the base grille and move the refrigerator to its final location. Tools Needed: ¼" hex driver Tools Provided: ¼" hex key 1. Use a ¼" hex nut driver to remove both screws in base grille. 2. Remove the base grille. Using both hands, grasp the grille firmly and pull it toward you. Open the freezer drawer to access the brake feet. NOTE: To allow the refrigerator to roll easier, raise the brake feet by turning them counterclockwise. The front rollers will be touching the floor. 15