Whirlpool WRF995FIFZ Use & Care Guide - Page 23
Water and Ice Dispensers
View all Whirlpool WRF995FIFZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Water and Ice Dispensers IMPORTANT: ■■ Allow 3 hours for the refrigerator to cool down and chill water. ■■ Allow 24 hours to produce the first batch of ice. Discard the first 3 batches of ice produced. ■■ The dispensing system will not operate if the left refrigerator door is not closed completely. ! Replace OrdFeirlteFrilter ! Door Ajar ! Dispense ! Calibration ! a1 oz = b1 L "#$#!a2 oz =! b2 L ! a3 oz =! b3 L ! A B Calibrate Measured Fill Household water pressure may affect the accuracy of the Measured Fill feature. So, for optimum performance of your water dispenser, you must first calibrate Measured Fill. IMPORTANT: ■■ Flush the water system before calibrating Measured Fill. ■■ For best results, calibration should be performed when water is not being used in the house. 1. Place a sturdy measuring cup (1-cup [237 mL] size) on the dispenser tray centered in front of the ice/water dispenser paddle. NOTE: Depending on your model, a measuring cup may be provided. ! Replace OrdFeirlteFrilter ! Door Ajar ! Dispense ! Calibration ! a1 oz = b1 L "#$#!a2 oz =! b2 L ! a3 oz =! b3 L ! A B C A. Water dispenser paddle B. Ice dispenser paddle Flush the Water System Air in the water dispensing system can cause the water dispenser to drip. After connecting the refrigerator to a water source or replacing the water filter, flush the water system. Flushing the water dispensing system forces air from the water line and filter and prepares the water filter for use. Additional flushing may be required in some households. NOTE: As air is cleared from the system, water may spurt out of the dispenser. 1. Using a sturdy container, depress and hold the water dispenser paddle for 5 seconds. 2. Release the dispenser paddle for 5 seconds. Repeat steps 1 and 2 until water begins to flow. 3. Once water begins to flow, continue depressing and releasing the dispenser pad (5 seconds on, 5 seconds off) until a total of 3 gal. (12 L) has been dispensed. A. Water dispenser paddle B. Ice dispenser paddle C. Measuring cup (1 cup) 2. Touch and hold the Measured Fill button for 3 seconds. The Calibration and Measured Fill icons will illuminate and remain lit while the Measured Fill feature is being calibrated. NOTE: You may touch any button to exit Measured Fill at any time in Calibration mode. The Calibration and Measured Fill icons will disappear. 3. Press and hold the water dispenser paddle, as needed, to dispense water to the 1-cup fill line in the measuring cup. NOTE: If overfilling or spilling occurs, discard the water and restart the calibration process. 4. When 1 cup of water has been correctly dispensed into the measuring cup, touch the center of the ring button to confirm the calibration. 5. When Measured Fill calibration has been confirmed, the Calibration icon will disappear and the display will return to the home screen. 23