Whirlpool WRS970CIDM Use & Care Guide - Page 25

PERFORMANCE DATA SHEET Water Filtration System Model P8WB2L/P8RFWB2L Capacity 200 Gallons (757 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42, Standard 53, and Standard 401 for the reduction of contaminants specified on the Performance Data Sheet. This system has been tested according to NSF/ANSI Standards 42, 53 and 401 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI Standards 42, 53, and 401. Substance Reduction Aesthetic Effects Influent Challenge Concentration Chlorine Taste/Odor Particulate Class I* Contaminant Reduction 2.0 mg/L ± 10% At least 10,000 particles/mL Influent Challenge Concentration Lead: @ pH 6.5 / @ pH 8.5 Benzene p-Dichlorobenzene Carbofuran Toxaphene Atrazine Asbestos Live Cysts† Turbidity Lindane Tetrachloroethylene o-Dichlorobenzene Ethylbenzene 1,2,4-Trichlorobenzene 2,4 - D Styrene Toluene Endrin Atenolol Trimethoprim Linuron Estrone Nonylphenol 0.15 mg/L± 10% 0.015 mg/L ± 10% 0.225 mg/L ± 10% 0.08 mg/L ± 10% 0.015 ± 10% 0.009 mg/L ± 10% 107 to 108 fibers/L†† 50,000/L min. 11 NTU ± 10% 0.002 ± 10% 0.015 mg/L ± 10% 1.8 mg/L ± 10% 2.1 mg/L ± 10% 0.210 mg/L ± 10% 0.210 mg/L ± 10% 2.0 mg/L ± 10% 3.0 mg/L ± 10% 0.006 mg/L ± 10% 200 ± 20% 140 ± 20% 140 ± 20% 140 ± 20% 1400 ± 20% Maximum Permissable Product Water Concentration 50% reduction 85% reduction Maximum Permissable Product Water Concentration 0.010 mg/L 0.005 mg/L 0.075 mg/L 0.040 mg/L 0.003 mg/L 0.003 mg/L 99% 9 9.95% 0.5 NTU 0.0002 mg/L 0.005 mg/L 0.60 mg/L 0.70 mg/L 0.07 mg/L 0.07 mg/L 0.1 mg/L 1.0 mg/L 0.002 mg/L 30 ng/L 20 ng/L 20 ng/L 20 ng/L 200 ng/L Average% Reduction 97.0% >99.9% Average% Reduction >99.3% / 98.6% 93.8% 99.8% 81.9% >95% 87.0% >99% >99.99% 96.9% >99.2% 96.6% 92.3% 86.9% >99.8% 88.5% 99.6% 93.5% 81.7% 95.7% 96.1% 96.3% 95.3% 95.5% Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.75 gpm (2.84 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 200 gallons (757 liters). The compounds certified under NSF 401 have been deemed as "emerging compounds/incidental contaminants." Emerging compounds/incidental contaminants are those compounds that have been detected in drinking water supplies at trace levels. While occurring at only trace levels, these compounds can affect the public acceptance/perception of drinking water quality. It is important that operational, maintenance, and filter replacement Do not use with water that is microbiologically unsafe or of unknown requirements be carried out for the product to perform as advertised. quality without adequate disinfection before or after the system. Property damage can occur if all instructions are not followed. Systems certified for cyst reduction may be used on disinfected The disposable cartridge must be changed at least every 6 months. Use replacement filter P8RFWB2L, part #EDR1RXD1/EDR1RXD1B. 2015 suggested retail price of $49.99 U.S.A./$49.99 Canada. Prices are subject to change without notice. The filter monitor system measures the amount of water that passes waters that may contain filterable cysts. EPA Est. No. 082047-TWN-001 Refer to the "Warranty" section (in the User Instructions or User Guide) for the Manufacturer's limited warranty, name and telephone number. through the filter and alerts you when it is time to replace the filter. Refer to the "Using the Controls" or "Water Filtration System" section Application Guidelines/Water Supply Parameters (in the User Instructions or User Guide) to learn how to check the water filter status. Water Supply Water Pressure City or Well 30 - 120 psi (207 - 827 kPa) After changing the water filter, flush the water system. See "Water and Ice Dispensers" or "Water Dispenser" in the User Instructions or Water Temperature Service Flow Rate 33° - 100°F (0.6° - 37.8°C) 0.75 gpm (2.84 L/min.) @ 60 psi User Guide. These contaminants are not necessarily in your water supply. While testing was performed under standard laboratory conditions, actual performance may vary. The product is for cold water use only. The water system must be installed in compliance with state and local laws and regulations. *Class I particle size: >0.5 to