Whirlpool WTW2000H Owners Manual
Whirlpool WTW2000H Manual
 |
View all Whirlpool WTW2000H manuals
Add to My Manuals
Save this manual to your list of manuals |
Whirlpool WTW2000H manual content summary:
- Whirlpool WTW2000H | Owners Manual - Page 1
WASHER USE AND CARE GUIDE Table of Contents WASHER SAFETY 2 INSTALLATION REQUIREMENTS 3 PERMANENT INSTALLATION INSTRUCTIONS 6 PORTABLE INSTALLATION INSTRUCTIONS 10 CONTROL PANEL AND FEATURES 13 USING YOUR WASHER 15 WASHER MAINTENANCE 18 TROUBLESHOOTING 20 WARRANTY 25 W11254174A - Whirlpool WTW2000H | Owners Manual - Page 2
WASHER SAFETY 2 - Whirlpool WTW2000H | Owners Manual - Page 3
INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. The parts supplied are in the washer basket. Portable Installation Parts supplied: Permanent Installation Parts needed (not provided with washer): NOTE: Replace inlet hoses after 5 years of - Whirlpool WTW2000H | Owners Manual - Page 4
please refer to the back cover of this manual. If You Have: You Will Need to washer on carpeting is not recommended. ■■ A sturdy floor to support the washer weight (washer, water, and load) of 225 lbs be considered for ease of installation and servicing. ■■ Additional clearances may be required - Whirlpool WTW2000H | Owners Manual - Page 5
Stacked 3" (76 mm) 12" (305 mm) 3" (76 mm) 12" (305 mm) DRYER 48 in.2 (310 cm2) ■■ Check with a qualified electrician if you are not sure the washer is properly grounded. ■■ Do not have a fuse in the neutral or ground circuit. WASHER 1" (25 mm) 24 in.2 (155 cm2) 1" (25 mm) Recessed area 1" ( - Whirlpool WTW2000H | Owners Manual - Page 6
be at least 39" (990 mm) high and no higher than 72" (183 cm) from the bottom of the washer. PERMANENT INSTALLATION INSTRUCTIONS Install Leveling Feet - Optional (for permanent installation only) IMPORTANT: Installation of the leveling feet is permanent. Once the leveling feet are installed into - Whirlpool WTW2000H | Owners Manual - Page 7
■■ To avoid damage to the floor, set the washer onto cardboard before moving across floor. ■■ Move the washer to within approximately 3 ft (900 mm) of the final location. Connect Drain Hose 2. Attach drain hose to drain port 4. R emove drain hose form (Floor drain installations only) If clamp is - Whirlpool WTW2000H | Owners Manual - Page 8
7. Clear water lines 9. Check for leaks Run water for a few seconds through hoses into a laundry tub, drainpipe, or bucket to avoid clogs. Water should run until clear. Make note of which hose is connected to hot water to help in attaching hoses to washer correctly. 8. Connect inlet hoses to - Whirlpool WTW2000H | Owners Manual - Page 9
: 11. Check levelness of washer B C A Move the washer to its final location. Place a level even with top edges of washer (B). Use side seam as a guide to check levelness of sides (A). Check levelness of front using lid, as shown (C). Rock washer back and forth to make sure all 4 feet make solid - Whirlpool WTW2000H | Owners Manual - Page 10
Insert new flat washer into inlet hose To keep the fill-and-drain hose from leaking, it must be installed according to the following instructions. IMPORTANT: To ensure proper installation, this procedure must be followed exactly. Wet inside end of the drain hose with tap water. IMPORTANT: Do not - Whirlpool WTW2000H | Owners Manual - Page 11
5. Secure drain hose ((66 1¼mm⁄4""mm)) Drain hose Clamp Cabinet 1¼⁄4"" ((66 mmmm)) 8. Set TEMP to Tap Cold Place clamp over area marked "CLAMP." Release clamp. 6. Attach faucet kit adapter to faucet Washer Adapter Set the temperature setting on your washer to Tap Cold. Set the water - Whirlpool WTW2000H | Owners Manual - Page 12
Disconnect Washer 1. Remove fill-and-drain hose connector from faucet Red water-flow button Turn off water faucets and unplug the power cord. Press the red water-flow button to release water pressure in the hose. Pull the locking collar down to remove the connector from the faucet. 2. Replace fill - Whirlpool WTW2000H | Owners Manual - Page 13
Clean Washer. 76 TEMP Select a wash temperature based on the type of fabric and soils being washed. For best results and following the garment label instructions, use the warmest wash water safe for your fabric. CONTROL LOCK Press and hold TEMP for 3 seconds to lock the controls. Press and hold for - Whirlpool WTW2000H | Owners Manual - Page 14
Dispensers B Cycle Guide A C A Liquid fabric softener dispenser Pour measured liquid fabric , or homemade HE detergents may generate a high level of suds. Follow the manufacturer's instructions to determine the amount of detergent to use. This section describes the available wash cycles and - Whirlpool WTW2000H | Owners Manual - Page 15
. Synthetics, knits, and corduroy fabrics will pick up lint from towels, rugs, and chenille fabrics. NOTE: Always read and follow fabric care labels instructions to avoid damage to your items. IMPORTANT: If you are using the Compact Dryer Stack Stand (Part Number 49971), pull the washer forward - Whirlpool WTW2000H | Owners Manual - Page 16
their ability to reduce suds. For example, natural, organic, or homemade HE detergents may generate a high level of suds. Follow the manufacturer's instructions to determine the amount of detergent to use. NOTES: ■■ Use only powdered HE detergent in the detergent dispenser. Add liquid HE detergent - Whirlpool WTW2000H | Owners Manual - Page 17
Selecting Water Temperatures NOTE: Always read and follow fabric care label instructions to avoid damage to your items. Wash Temp Suggested Fabrics Hot cycle Press the CYCLES button to select your wash cycle. See "Cycle Guide" for details on cycle features. 10. Press START/PAUSE to begin wash - Whirlpool WTW2000H | Owners Manual - Page 18
to Help Keep Your Washer Clean and Performing at Its Best 1. Always use High Efficiency (HE) detergents and follow the HE detergent manufacturer's instructions regarding the amount of HE detergent to use. Never use more than the recommended amount because that may increase the rate at which - Whirlpool WTW2000H | Owners Manual - Page 19
onto the ground. Reinstalling/using washer again To reinstall washer after non-use, vacation, winter storage, or moving: 1. Refer to Installation Instructions to locate, level, and connect washer. 2. Before using again, run washer through the following recommended procedure: To use washer again - Whirlpool WTW2000H | Owners Manual - Page 20
TROUBLESHOOTING First try the solutions suggested here for assistance and to possibly avoid a service not suitable for selected cycle. See "Cycle Guide" and "Using Your Washer." Noises Clicking or tub. See "Using Your Washer" for loading instructions. Washer not performing as expected Not enough - Whirlpool WTW2000H | Owners Manual - Page 21
TROUBLESHOOTING First try the solutions suggested here for assistance and to possibly avoid a service call. If you experience outlet. Reset a tripped circuit breaker. Replace any blown fuses. NOTE: If problems continue, contact an electrician. Normal washer operation. Lid must be closed for - Whirlpool WTW2000H | Owners Manual - Page 22
TROUBLESHOOTING First try the solutions suggested here for assistance and to possibly avoid a service call. If you experience Possible Causes than 4.5" (114 mm). See "Vibration or Off-Balance" in "Troubleshooting" section for more information. Check drain hose for proper installation. Use drain - Whirlpool WTW2000H | Owners Manual - Page 23
TROUBLESHOOTING First try the solutions suggested here for assistance and to possibly avoid a service call. If you experience after washer has started. Always read and follow garment manufacturer's care label instructions. See the "Cycle Guide" to match your load with the best cycle. Do not pour - Whirlpool WTW2000H | Owners Manual - Page 24
TROUBLESHOOTING First try the solutions suggested here for assistance and to possibly avoid a service call. If you experience Possible packet is added to washer basket before adding clothes. Follow the manufacturer's instructions to avoid damage to your items. Error Code Appears in Display E1 - Whirlpool WTW2000H | Owners Manual - Page 25
service. Please take a few minutes to review the Troubleshooting section of the Use and Care Guide or visit producthelp.whirlpool.com. 2. All warranty service is provided exclusively by our authorized Whirlpool Service operated, and maintained according to instructions attached to or furnished with
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
 |
 |
Designed to use only HE High Efficiency detergents.
Diseñada para utilizar solamente detergentes de alto rendimiento (HE).
WASHER
USE AND CARE GUIDE
Table of Contents
WASHER SAFETY
.....................................................................
2
INSTALLATION REQUIREMENTS
............................................
3
PERMANENT INSTALLATION INSTRUCTIONS
......................
6
PORTABLE INSTALLATION INSTRUCTIONS
........................
10
CONTROL PANEL AND FEATURES
......................................
13
USING YOUR WASHER
..........................................................
15
WASHER MAINTENANCE
......................................................
18
TROUBLESHOOTING
.............................................................
20
WARRANTY
.............................................................................
25
W11254174A
W11254180A-SP