Whirlpool WTW2000H Owners Manual - Page 6

Drain System The washer can be installed using the standpipe drain system (floor or wall), the laundry tub drain system, or the floor drain system. Select the drain hose installation method you need. See "Tools and Parts." Standpipe drain system - wall or floor (views A & B) The standpipe drain requires a minimum diameter standpipe of 2" (50 mm). The minimum carry-away capacity (for permanent installations) can be no less than 17 gal. (64.5 L) per minute. The top of the standpipe must be at least 39" (990 mm) high and no higher than 72" (183 cm) from the bottom of the washer. PERMANENT INSTALLATION INSTRUCTIONS Install Leveling Feet - Optional (for permanent installation only) IMPORTANT: Installation of the leveling feet is permanent. Once the leveling feet are installed into the base of the washer, they cannot be removed and the washer wheels will no longer be able to roll. 4.5" (114 mm) A 4.5" (114 mm) 1. Install leveling feet Front Large black rubber foot B Laundry tub drain system (view C) The laundry tub requires a minimum carry-away capacity of 17 gal. (64.5 L) per minute (for permanent installations). The top of the laundry tub must be at least 39" (990 mm) above the floor and no higher than 72" (183 cm) from the bottom of the washer. 4.5" (114 mm) mmiinn.. 3390"" (979602 mm) Lay washer on its back. Push in to snap the large black rubber foot into the right front corner of the washer base. Repeat to install the remaining leveling feet on the other 3 corners. C 6