Whirlpool WTW2000H Owners Manual - Page 13
Control Panel And Features
View all Whirlpool WTW2000H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
CONTROL PANEL AND FEATURES 12 3 4 5 4 6 7 1 LED TIME/STATUS DISPLAY The Remaining Time display shows the time required for the cycle to complete. Factors such as load size and water pressure may affect the time shown in the display. Tightly packed loads, unbalanced loads, excessive suds, or adding or removing items may cause the washer to adjust the cycle time as well. 2 LID LOCK The Lid Lock indicator lights up when the lid is locked and cannot be opened. If you need to open the lid, press and hold START/PAUSE. The lid will unlock 1 minute after the washer movement has stopped. This may take several minutes if the load was spinning at high speed. Press the START/PAUSE button again to restart the cycle. 3 START/PAUSE After selecting a wash cycle, press START/PAUSE to start the cycle. Press once to pause a cycle. The flashing lights indicate the selected cycle and the current process. 4 CYCLE TIME (+ or -) ■■ Press "+" or "-" to adjust the duration of a cycle. ■■ LED display will show the time remaining for the cycle to complete. ■■ If an out-of-range adjustment is made, a buzzer will sound. End-of-Cycle Signal Press and hold the minus (-) button for 3 seconds to enable or disable the end-of-cycle signal. 5 CYCLES Press CYCLES to select a wash cycle. Choose from Normal, Delicate, Heavy Duty, Rinse, Spin, or Clean Washer. 76 TEMP Select a wash temperature based on the type of fabric and soils being washed. For best results and following the garment label instructions, use the warmest wash water safe for your fabric. CONTROL LOCK Press and hold TEMP for 3 seconds to lock the controls. Press and hold for 3 seconds to unlock. You may still press POWER ON/OFF to turn off the washer. 7 POWER ON/OFF Press POWER ON/OFF to turn on or off the washer. Press once while a cycle is running to stop the washer. 13