Yamaha CVP-309PM Owner's Manual - Page 206
CVP-309 grand piano type: Keyboard Stand Assembly
View all Yamaha CVP-309PM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 206 highlights
CVP-309 grand piano type: Keyboard Stand Assembly CAUTION • Be careful not to confuse parts, and be sure to install all parts in the correct orientation. Please assemble in accordance with the sequence given below. • Assembly should be carried out by at least two persons. • Be sure to use the correct screw size, as indicated below. Use of incorrect screws can damage the stand. • Be sure to tighten all screws upon completing the assem- bly of each unit. • To disassemble, reverse the assembly sequence given below. Have a Phillips-head (+) screwdriver ready. How to position the main unit CAUTION Be careful not to pinch your fingers. Protective pad Floppy disk drive Large soft cloth n The CVP-309 grand piano type features an iAFC (Instrumental Active Field Control) effect. This produces sound from the speaker located on the bottom face of the Clavinova, enhancing the reverberation and spaciousness of the sound when you open the lid with the longer stay (page 16). In order to optimize the iAFC effect, please observe the following: • Perform the automatic adjustment after you turn on the power of the Clavinova for the first time, and after each time you re-locate the Clavinova (page 77). • Do not block the speaker located on the bottom face of the Clavinova. 1 Remove all parts from the box. Confirm that all parts shown in the illustration are included. Main unit CAUTION To prevent the key cover from accidentally opening during assembly, press down on the key cover, making sure that the sheet (shown) remain in place. Legs 6 × 40 mm fixing screws × 12 Pedal box 6 × 20 mm fixing screws × 4 AC power cord Cord holder Floppy disk drive Protective pad 1 Spread a large soft cloth such as a blanket on the floor in front of the wall. 2 Place a protective pad on the soft cloth, so that, when you place the main unit flat on the floor with its keyboard side facing the wall, the pad will be located about 10cm (a little more than four inches) to the high key side from the floppy disk drive as shown in the illustration. The pad will protect the floppy disk drive so that it will not be damaged by touching the floor. 3 As shown in the illustration, place the main unit flat on the floor so that half of the pad underneath protrudes from the keyboard side of the unit, and at the same time the pad is located about 10cm to the high key side from the floppy disk drive. Then raise the rear of the main unit until it leans against the wall with the keyboard side at the bottom. Be careful not to allow the unit to fall or slip. Place a soft cloth against the wall to protect the unit and the wall from scratches. CAUTION Be sure to use a protective pad to avoid a damage to the floppy disk drive. If the drive touches the floor when you raise the unit to lean it against the wall, too much pressure may be applied to the drive, possibly causing serious damages to the drive. CAUTION • Do not place the main unit with the rear side facing down. Incorrect • Do not lay the main unit upside down on the floor. • Do not position the main unit so that its bottom is in contact with floor. Incorrect Incorrect Protective pad Appendix 206 CVP-309/307 Owner's Manual