Yamaha CVP-89 Owner's Manual - Page 72

i Assembly/Zusammenbau/Montage/Montaje 1 5 x 20 mm screws 5 x 20 mm Schrauben Vis de 5 x 20 mm Tornillos de 5 x 20 mm x18 1 4 x 20 mm round-head screws 4 x 20 mm Rundkopfschrauben x5 2 Vis à tête ronde de 4 x 20 mm Tornillos de cabeza redonda de 4 x 20 mm 2 3 Blanket, etc. Decke o.ä. Couverture, etc. Manta, etc. 4 Four 5 x 20mm screws 1 Vier 5 x 20 mm Schrauben 1 Quatre vis de 5 x 20 mm 1 Cuatro tornillos de 5 x 20 mm 1 Black Schwarz Noir Negro Six 5 x 20 mm screws 1 Sechs 5 x 20 mm Schrauben 1 Six vis de 5 x 20 mm 1 Seis tornillos de 5 x 20 mm 1 White Weiß Blanc Blanco Black Schwarz Noir Negro Five 4 x 20 mm round-head screws 2 Fünf 4 x 20 mm Rundkopfschrauben 2 Cinq vis à tête ronde de 4 x 20 mm 2 Cinco tornillos de cabeza redonda de 4 x 20 mm 2 Two 5 x 20 mm screws 1 Zwei 5 x 20 mm Schrauben 1 Deux vis de 5 x 20 mm 1 Dos tornillos de 5 x 20 mm 1 Assembly NOTES • We do not recommend attempting to assemble the Clavinova alone. The job can be easily accomplished, however, with only two people. • Use only the screws provided or replacements of exactly the specified size. Using screws of the wrong size can result in damage to the instrument. ZOpen the box and remove all the parts. On opening the box you should find the parts shown in the illustration above. Check to make sure that all the required parts are provided. XCarefully lean the main unit against a wall. To make it easier to install the legs, place a soft blanket or similar material on the floor near a wall, close the Clavinova keyboard cover, place the front panel of the Clavinova (the side with the keyboard) on the blanket and gently lean the unit against the wall - MAKING SURE THAT IT CAN NOT FALL - as shown in the illustration. CAttach the front legs. Securely attach the two front legs using six 5 x 20 mm screws 1 each (use a Philips "+" screwdriver), as shown in the illustration. Make sure the screws are securely tightened. VAttach the rear leg and pedal box assembly. Before attaching the rear leg and pedal box assembly, insert the 3 plugs extending from the rear leg into the corresponding sockets in the main unit, making sure that the connectors must be inserted with the protruding clip facing the rear of the main unit. Then securely attach the rear leg with the six 5 x 20 mm screws 1, and the pedal bracket with the five 4 x 20 mm round-head screws 2. IMPORTANT • After assembling the Clavinova, check once more to make sure that all screws have been securely fastened. • If the stand leans to the side, makes unusual noises, or otherwise seems unstable during use, check and tighten all screws while following the assembly instructions given above.