Yamaha EMX5014C Owner's Manual - Page 27
Rear Panel, SPEAKERS jacks, POWER Switch, AC IN Connector, Ground Screw
UPC - 086792838274
View all Yamaha EMX5014C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Rear Panel Reference Front & Rear Panels h k ji h SPEAKERS jacks Use these jacks to connect to speakers. Note that the output directed to these jacks varies according to the setting of the POWER AMP switch Y. A1, B1: NEUTRIK NL4 Speakon outputs. Polarities are as shown below. 1- 1+ Neutrik Plug A1 and B1 Connectors 1+ + 1- - 2+ 2+ 2- 2- A2, B2: Phone output jacks. i POWER Switch This switch turns the EMX power ON and OFF. The POWER indicator U lights up when this switch is on. Before turning the power ON or OFF, be sure to turn both the ST master fader and the AUX1 and AUX2 faders are all the way down. j AC IN Connector Connect the included power cable here. Connect one end of the cord to this connector, and then plug the other end into a standard power outlet. Before turning the power ON or OFF, be sure to turn both the ST master fader and the AUX1 and AUX2 faders are all the way down. k Ground Screw For maximum safety be sure to securely connect the EMX to an earth connection. The supplied power cable has a three-prong plug that will ground the unit when the plug is inserted into an appropriately grounded three-prong type AC mains outlet. If the AC outlet is not grounded, be sure to ground the unit by using this ground screw. Correct grounding will effectively eliminate hum noise and interference. EMX5014C Owner's Manual 27