Yamaha KX-W392 Owner's Manual - Page 11
AR BL AR BL, incorporates both Dolby B NR and the newer Dolby C NR
View all Yamaha KX-W392 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
ENGLISH FRANÇAIS DEUTSCH SVENSKA Digital Super Surround (DSS) setting (in step 2) (KX-W592 only) The DSS function can be utilized also for recording. Press the DSS MODE button to turn on the DSS function, and select one of the DSS programs by pressing the DSS button so that the corresponding indicator lights up. By recording with this function, you can enjoy the sources with your preferred DSS effect even when played back on car audios or portable headphone stereo systems. For details on DSS, see page 9. DOLBY NR selector setting (in step 3) Set the DOLBY NR selector according to your purpose. OFF: No noise reduction. B: For recording the sources with Dolby B NR. C: For recording the sources with Dolby C NR. ÷ Dolby noise reduction is an extremely effective method of reducing undesirable background hiss on tapes. This unit incorporates both Dolby B NR and the newer Dolby C NR system. Dolby C NR is approximately twice as effective as the earlier Dolby B NR. REVERSE MODE selector setting (in step 4) The auto reverse function allows the tape running direction to be reversed automatically. Select the auto reverse mode ( ), manual reverse mode ( ) or the RELAY (KX-W592 only) recording mode. : When recording on one side of a tape is finished, the deck stops at the end of the tape. :Both sides of a tape are recorded. After recording, the deck stops at the end of the tape. ÷ When the tape running direction is set to ™, only the reverse side is recorded. ÷ KX-W592 If you select , the reverse mode automatically switches to in step 6. If you select RELAY , the reverse mode automatically switches to RELAY in step 6. ÷ KX-W492 and KX-W392 If you select or RELAY , the reverse mode automatically switches to in step 6. Setting the recording level (in step 7) Play the loudest passage of the source to be recorded and watch the meter readings. Adjust the REC LEVEL control so that the highest peak reaches +4 of the optimum recording level. Normally, it is best to adjust the REC BALANCE control (KX-W592 and KX-W492 only) such that the left and right meter readings are even. Display during recording The A or B indicator shown in the display represents the last deck operated. KX-W592 Tape counter Use the tape counter to aid in locating a point on a tape (0000 to 9999). To set the counter reading to "0000", press the RESET button. Tape running direction indicator REC indicator MODE indicator DOLBY B/ C indicator REC indicator DSS PRESET PROGRAM indicators ¤A‹ RELAY REC HALL DISCO CHURCH JAZZ ¤B‹ B C REC L - 30 dB 20 15 10 8 6 R 4 2 0 2 4 6+ Peak level meters Indicate the peaks of the signal levels during recording and playback over a -30 dB to +6 dB range. There are separate meters for each left and right channel. These level meters have a peak hold function which holds the peak level for about 1.5 seconds. KX-W492/ KX-W392 Displayed indicators represent the same functions as shown above. ¤A‹ RELAY ¤ B ‹ B C REC L - 30 dB 20 15 10 8 6 R 4 2 0 2 4 6+ ITALIANO ESPAÑOL DUTCH To stop recording: Press the STOP button. To stop recording temporarily: Press the REC/PAUSE button. To resume recording, press the PLAY button. 11