Yamaha MCR-E600 MCR-E600 Owners manual Receiver only - Page 5

English GETTING STARTED Remote control This remote control controls a whole system: not only RX-E600 but also DVD-E600. Moreover, a cassette deck (KX-E300) and MD recorder (MDX-E300) that level up your system can be operated by it. Operating buttons for each unit are explained on the pages below: Receiver, RX-E600: DVD player, DVD-E600: Cassette deck, KX-E300: MD recorder, MDX-E300: @P.8 @P.18 @P.23 @P.23 Battery installation 1 3 2 Remote control operation range STANDBY/ON TIMER PHONES NATURAL SOUND STEREO RECEIVER RX-E600 VOLUME DISPLAY MEMORY AUTO/MAN'L PRESET/BAND PRESET/TUNING TIMER ADJ BASS TIMER TREBLE HOUR MIN BALANCE - + - + L R MIN MAX INPUT Remote control sensor Within approximately 6 m (20 feet) 30° 30° 1 Remove the battery compartment cover. 2 Insert batteries into the battery compartment. 3 Replace the battery compartment cover. Battery replacement If you find that the remote control must be used closer to the main unit than usual, the batteries are weak. Replace batteries with new ones. Notes • Use only AA, R6, UM-3 batteries for replacement. • Be sure the polarities are correct. (See the illustration inside the battery compartment.) • Remove the batteries if the remote control will not be used for an extended period of time. • If batteries leak, dispose of them immediately. Avoid touching the leaked material or letting it come in contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries. POW ER 2 3 3 6 6 Notes • There should be no large obstacles between the remote control and the main unit. • If the remote control sensor is directly illuminated by strong lighting (especially an inverter type of fluorescent lamp, etc.), it might cause the remote control not to work correctly. In this case, reposition the main unit to avoid direct lighting. Removing the protection sheet The remote control is shipped with a protection sheet to prevent the surface from being scratched during transportation. When removing the sheet, first put adhesive tape on an edge of the remote control so that the tape sticks to the sheet. Then peel the sheet off with the tape. POW ER 2 3 3 6 6 9 2 9 5 5 1 5 4 2 1 5 8 1 8 1 4 8 8 4 4 7 7 7 7 Note • Do not scratch the remote control surface when peeling the sheet off. 0104CRXE400(M).03-08.E 3 3 2004.06.15, 19:06