Yamaha NX-SW10 Owner's Manual

Yamaha NX-SW10 Manual

Get Yamaha NX-SW10 PDF manuals and user guides View all Yamaha NX-SW10 manuals
Add to My Manuals
Save this manual to your list of manuals

Yamaha NX-SW10 manual content summary:

  • Yamaha NX-SW10 | Owner's Manual - Page 1
    UCA NX-SW10 Subwoofer/Center Speaker/Rear Speakers Caisson de grave/Enceinte centrale/ Enceintes arriere OWNER'S MANUAL MODE D'EMPLOI MANUAL DE INSTRUCCIONES
  • Yamaha NX-SW10 | Owner's Manual - Page 2
    you to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING TO REDUCE your outlet, consult an electrician for replacement of the obsolete outlet. 10 Protect the power cord from being walked on or pinched particularly at
  • Yamaha NX-SW10 | Owner's Manual - Page 3
    instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha " and "ON", please try to eliminate the problem by using one of the following measures: Relocate , change the lead-in to coaxial type cable. If these corrective measures do not produce
  • Yamaha NX-SW10 | Owner's Manual - Page 4
    TROUBLESHOOTING" section regarding common operating errors before concluding that the unit is faulty. 11 Secure placement or installation is the owner's responsibility. YAMAHA shall not be liable for any accident caused by improper placement or installation of speakers. s For SW-VS10 10 instructions
  • Yamaha NX-SW10 | Owner's Manual - Page 5
    Control with the VS-10 (sold separately) The VS-10 is used to do things such as adjust the subwoofer level and adjust the speaker level using test tones. Refer to the VS-10 (sold separately) owner's manual. q Advanced YST v This subwoofer incorporates advanced YAMAHA Active Servo Technology
  • Yamaha NX-SW10 | Owner's Manual - Page 6
    behind or to the sides of the listening position. s Subwoofer (SW-VS10) Place the subwoofer at the outside of the either right or left main the television as close to the television monitor as possible. s YAMAHA main speakers NX-VS10M (sold separately) Place the main speakers an equal distance from
  • Yamaha NX-SW10 | Owner's Manual - Page 7
    the instructions for each component to be connected to this unit. Connecting the Center Speaker and the Rear Speakers to the Subwoofer Note • Do not connect any speakers to the speaker terminals on the subwoofer except for the supplied center speaker (NX-VS10C) and rear speakers (NX-
  • Yamaha NX-SW10 | Owner's Manual - Page 8
    CONNECTIONS s Connecting the speaker cords to the speaker terminals on the subwoofer 3 1 Tab 2 Bare wire 1 Open the tab for the + terminal (red) or the - terminal (black). 2 Insert the bare wire of the speaker cord into the hole. 3
  • Yamaha NX-SW10 | Owner's Manual - Page 9
    the VS-10 (sold separately) to the SYSTEM CONNECTOR terminal on the subwoofer using the system connector cable. Match the mark on the plugs with those on the terminals and insert the plugs. VS-10 (sold separately) VIDEO SIGNAL MONITOR OUT + DO NOT CONNECT THIS UNIT TO SPEAKERS OTHER THAN NX-VS10M
  • Yamaha NX-SW10 | Owner's Manual - Page 10
    INSTALLATION OF THE CENTER SPEAKER To prevent the center speaker from falling, secure it with the supplied velcro strips when placing it on a television or other device. Using the Velcro Strips Precautions before installation • Do not touch the adhesive surface after peeling off the strip as this
  • Yamaha NX-SW10 | Owner's Manual - Page 11
    INSTALLATION OF THE REAR SPEAKERS Use the supplied type A wall brackets when hanging the rear speakers on a wall. 1 Attach two commercially available wood screws (diameter about 4 mm) in the location on the wall where the rear speaker is to be hung, and then mount the type A bracket on the wood
  • Yamaha NX-SW10 | Owner's Manual - Page 12
    so that they will not catch on hands or feet, causing speakers to drop. • Be absolutely sure to check for safety after speakers are mounted. YAMAHA bears no responsibility for damage caused due to improper installation or installation in an improper location. 60 mm 8
  • Yamaha NX-SW10 | Owner's Manual - Page 13
    selector of VS-10 set correctly? Refer to the owner's manual for the VS-10 (sold separately). • Are the headphones connected to the VS-10? Refer to the owner's manual for the VS-10 (sold separately). • Is the system connector cable connected correctly? • Is the subwoofer level of the VS-10 set too
  • Yamaha NX-SW10 | Owner's Manual - Page 14
    Subwoofer 50 W (100 Hz, 10% THD, 5 ohms) Center speaker 40 W (1 kHz, 10% THD, 6 ohms) Rear speakers 25 W x 2 (1 kHz, 10% THD, 6 ohms) Subwoofer (SW-VS10) Type .......... Advanced YAMAHA Speaker cords (15 m x 2, 4 m x 1) System connector cable (3 m x 1) Velcro strips (x 2) Type A brackets (x 2)
  • Yamaha NX-SW10 | Owner's Manual - Page 15
    ELECTRONIQUE FRANCE S.A. RUE AMBROISE CROIZAT BP70 CROISSY-BEAUBOURG 77312 MARNE-LA-VALLEE CEDEX02, FRANCE YAMAHA ELECTRONICS (UK) LTD. YAMAHA HOUSE, 200 RICKMANSWORTH ROAD WATFORD, HERTS WD1 7JS, ENGLAND YAMAHA SCANDINAVIA A.B. J A WETTERGRENS GATA 1, BOX 30053, 400 43 VÄSTRA FRÖLUNDA, SWEDEN
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
OWNER’S MANUAL
MODE D’EMPLOI
MANUAL DE INSTRUCCIONES
NX-SW10
Subwoofer/Center Speaker/Rear Speakers
Caisson de grave/Enceinte centrale/
Enceintes arriere
UCA