Yamaha NX-SW10 Owner's Manual - Page 8

CONNECTIONS s Connecting the speaker cords to the speaker terminals on the subwoofer 3 1 Tab 2 Bare wire 1 Open the tab for the + terminal (red) or the - terminal (black). 2 Insert the bare wire of the speaker cord into the hole. 3 Return the tab until it clicks. • Connect the line-in cord to the + terminal (red), and the other cord to the - terminal (black). • Once connected, pull gently on the speaker cords to check that they are connected securely. CAUTIONS • Do not let the bare speaker wire touch each other and do not let them touch any metal part of the speakers. This could damage the speakers. • Do not mistakenly connect positive (+) to negative(-) or vice versa when connecting speaker cords. • Insert the speaker cords securely so that positive (+) and negative (-) do not short. The speaker may not output any sound or may output noise, causing damage to the speakers, if speaker cords are not inserted securely. • Only insert the bare wire portion of the speaker cords into the holes. Sound will not be output if you insert as far as the plastic insulation part of the cord. • Secure the speaker cords so that they will not catch on hands or feet. s Connecting the speaker cords to the speaker terminals on the center speaker and the rear speakers 1 Hold down the tab. 2 Insert the bare wire of the speaker cord into 2 the hole. 3 Release the tab. (The tab will return to its 3 Bare wire original position when you release your finger.) Tab 1 • Connect the line-in cord to the + terminals (red) on the right, and the other cord to the - terminals (black) on the left. • Once connected, pull gently on the speaker cords to check that they are connected securely. 4