Yamaha Soavo-900SW Owner's Manual - Page 9
Preparing the remote control, Installing the batteries in the remote, control, Replacing the batteries
View all Yamaha Soavo-900SW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Preparing the remote control ■Installing the batteries in the remote control GETTING STARTED ■Using the remote control 3 1 2 Remote control sensor Approximately 6 m (20 ft) 1 Press the mark on the battery cover and open the cover. 2 Insert the two supplied type AA, R6, UM-3 batteries following the indications (+/-) inside the battery compartment. 3 Close the battery cover. Replacing the batteries Change all of the batteries if you notice conditions such as the operation range of the remote control decreases. Notes • Do not use an old battery together with a new one. • Do not use different types of batteries (for example, alkaline and manganese) together. Each type of battery has its own characteristics even if they are similar in shape. • If the batteries run out, immediately remove them from the remote control to prevent an explosion or acid leak. • Dispose of the batteries according to the regional regulations. • If a battery starts leaking, dispose of it immediately. Be careful not to let leaking battery acid come into contact with your skin or clothing. Before inserting new batteries, wipe the compartment clean. The remote control transmits a directional infrared ray. Be sure to aim the remote control directly at the remote control sensor on the main unit during operation. Handling the remote control Be careful not to spill liquid on the remote control. Be careful not to drop the remote control. Do not leave the remote control in the following places: - hot or humid places, such as near a heater or in a bathroom - extremely cold places - dusty places 5 En