Yamaha YDP-141 Owner's Manual - Page 34
-5, Attach B., Securely tighten the screws on C that were, attached in Step 1-3., Mount A.
View all Yamaha YDP-141 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
ENGLISH Keyboard Stand Assembly 2 Attach B. Depending on the model of digital piano you purchased, the surface color of one side of B may be different from the other side. In this case, position B so that the side of the surface color similar to D and E faces the player. 2-1 Place the lower side of B on each foot of D and E, then attach the upper side to D and E. 2-2 Attach the top of B to D and E by finger-tightening the thin screws (4 × 12mm). 2-3 While pushing the lower part of D and E from outside, secure the bottom ends of B using two tapping screws (4 × 20mm). 2-4 Insert the other two tapping screws (4 × 20mm) into the other two screw holes to secure B. 2-5 Securely tighten the screws on the top of B that were attached in Step 2-2. 2-1 E 2-2, 2-5 Place the bottom ends B of the rear panel on each foot. 2-3 2-4 L R D 2-3 4 Mount A. Be sure to place your hands at least 10 cm from either end of the main unit when positioning it. At least A 10 cm E At least 10 cm B D CAUTION • Fingers can become pinched between the main unit and the rear or side panels, be extra careful so as not to drop the main unit. • Do not hold the keyboard in any position other than the position shown in the illustration. 5 Secure A. 5-1 Adjust the position of A so that the left and right ends of A will project beyond D and E equally when seen from the front. 5-2 Secure A by tightening the short screws (6 × 16mm) from the front. 5-1 3 Securely tighten the screws on C that were attached in Step 1-3. Projection of A B C 3 A 5-2 34 YDP-161/141 Owner's Manual