Yamaha YDP-141 Owner's Manual - Page 35

110 ENGLISH 6 Connect the pedal cord. 6-1 Insert the pedal cord plug to the [PEDAL] jack from the rear. 6-2 Attach the cord holders to the rear panel as shown, then clip the cord into the holders. 6-3 Use a vinyl tie to take up any slack in the pedal cord. 6-1 Keyboard Stand Assembly YDP-141 7-1 Connect the DC plug of the power adaptor to the rear panel connector, and loop cord slack onto the cord hook so that the plug will not be disconnected accidentally. 6-3 6-2 7 Connect the power cord (for YDP-161) or power adaptor (for YDP-141) to the unit. YDP-161 7-1 Set the voltage selector (for models that feature a voltage selector). Voltage Selector Before connecting the AC power cord, check the setting of the voltage selector which is provided in some areas. To set the selector for 110V, 127V, 220V or 240V main voltages, use a "minus" screwdriver to rotate the selector dial so that the correct voltage for your region appears next to the pointer on the panel. The voltage selector is set at 240V when the unit is initially shipped. After the proper voltage has been selected, connect the AC power cord to the [AC IN] jack and an AC wall outlet. A plug adaptor may be also provided in some areas to match the pin configuration of the AC wall outlets in your area. 7-2 Connect the plug on the power cord to the rear panel connector. CAUTION • Do not bend the cord tightly when you hang the cord on the cord hook. Otherwise, a short-circuit or fire may result. WARNING • An improper voltage setting can cause serious damage to this instrument or result in improper operation. ■Connecting the pedal cord Insert the pedal cord securely until the metal part of the cord plug disappears from view. Otherwise, the pedal may not function properly. MIDI Insert the cord all the way until the metal part of the plug disappears from view. 7-2 240 7-1 220 127 YDP-161/141 Owner's Manual 35