Yamaha YDP-181 Owner's Manual - Page 60
Mount A., Secure A., Connect the pedal cord and the power, cord., Attach the cord holders to B
View all Yamaha YDP-181 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
ENGLISH Keyboard Stand Assembly 5. Mount A. Place your hands at least 10 cm from either end of A when positioning it. A At least 10 cm E At least 10 cm D 6. Secure A. 6-1 Adjust the position of A so that the left and right ends of A will project beyond D and E equally when seen from the front. 6-2 Secure A by tightening the short screws (6 x 16mm) from the front. 6-1 A Projection of A 7. Connect the pedal cord and the power cord. 7-1 Insert the pedal cord plug to the pedal connector from the rear. 7-2 Attach the cord holders to B, then clip the cord into the holders. 7-3 Use a vinyl tie to bundle the pedal cord. 7-4 For models that feature a voltage selector: Set the voltage selector to an appropriate voltage. Voltage Selector Before connecting the AC power cord, check the setting of the voltage selector which is provided in some areas. To set the selector for 110V, 127V, 220V or 240V main voltages, use a "minus" screwdriver to rotate the selector dial so that the correct voltage for your region appears next to the pointer on the panel. The voltage selector is set at 240V when the unit is initially shipped. After the proper voltage has been selected, connect the AC power cord to the AC INLET and an AC wall outlet. A plug adaptor may be also provided in some areas to match the pin configuration of the AC wall outlets in your area. WARNING An improper voltage setting can cause serious damage to this instrument or result in improper operation. 7-5 Insert the AC power cord plug into the AC INLET. 7-1 A 7-3 6-2 7-2 7-5 7-4 60 Owner's Manual