Yamaha YDP-S52 Owner's Manual - Page 31
Secure C., Mount A., Connect the pedal cord, x 16 mm from the bottom.
View all Yamaha YDP-S52 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
2-4 Securely tighten the screws on the top of B that were attached in Step 2-1. E 2-1, 2-4 D B 2-2 2-3 2-2 Secure the anti-fall brackets () using the screws. 3. Secure C. 3-1 Securely tighten the screws on C that were attached in Step 1-3. 3-2 Attach the caps () to the head of the screws. 3-2 D B E C 3-1 4. Mount A. Be sure to place your hands at least 10 cm from either end of A when positioning it. At least 10 cm At least 10 cm Keyboard Stand Assembly 5. Secure A. 5-1 Adjust the position of A so that the left and right ends of A will project beyond D and E equally when seen from the front. 5-2 Secure A by tightening the short screws (6 x 16 mm) from the bottom. 5-1 A Projection of A A 5-2 6. Connect the pedal cord 6-1 Insert the pedal cord plug to the [TO PEDAL] jack from the rear. 6-2 Attach the cord holders to the rear panel as shown, then clip the cord into the holders. 6-3 Use a vinyl tie (Step 1-1) to take up any slack in the pedal cord. 6-1 A 6-2 D B E Align the dowels on D and E with the corresponding holes on the bottom of A. CAUTION • Be careful not to pinch your fingers or drop the unit. • Do not hold the keyboard in any position other than the position shown in the illustration. 6-3 Insert the pedal cord securely until the metal part of the cord plug disappears from view. Otherwise, the pedal may not function properly. 31 YDP-S52 Owner's Manual