Yamaha YDP-V240 Owner's Manual - Page 117
Set the adjuster., Attach the headphone hanger., Remove the protective tapes - review
View all Yamaha YDP-V240 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
Keyboard Stand Assembly 8 Set the adjuster. 8-1 Rotate the adjuster until it comes in firm contact with the floor surface. 9 Attach the headphone hanger. 9-1 Install the headphone hanger using included two screws (4 x 10mm) as shown in the figure. ■ After completing the assembly, please check the following. • Are there any parts left over? ➔ Review the assembly procedure and correct any errors. • Is this instrument clear of doors and other movable fixtures? ➔ Move the instrument to an appropriate location. • Does this instrument make a rattling noise when you shake it? ➔ Tighten all screws. • Does the pedal box rattle or give way when you step on the pedals? ➔ Turn the adjuster so that it is set firmly against the floor. • Are the pedal and power cords inserted securely into the sockets? ➔ Check the connection. • If the main unit creaks or is otherwise unsteady when you play on the keyboard, refer to the assembly diagrams and retighten all screws. CAUTION • When moving the instrument after assembly, always hold the bottom of the main unit. Do not hold the key cover or top portion. Improper handling can result in damage to the instrument or personal injury. Do not hold here. ■ Remove the protective tapes Open the key cover and remove the protective tape on each side of the keyboard. Hold here. Owner's Manual 117