Yamaha YSP-3050 Owner's Manual - Page 105
ADDITIONAL, INFORMATION, English, Problem, Cause, Remedy
UPC - 027108930282
View all Yamaha YSP-3050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
Troubleshooting Problem Cause Remedy No sound from the subwoofer. BASS OUT in SUBWOOFER SET is set to Select SUBWOOFER. FRONT. The source does not contain low bass signals. Distorted or too little bass sound. CROSS OVER in SUBWOOFER SET is set Set CROSS OVER correctly. incorrectly. One of the night listening enhancers is currently selected. Turn off the night listening enhancers. Too much bass sound. TruBass is currently turned on. Turn off TruBass. The volume level of the subwoofer is too high. Turn down the volume level of the subwoofer. Surround sound effects are insubstantial. The listening room is not a regular shape. Install this unit in a square or rectangular shaped room. There is no wall in the path of the sound beam. Try placing a flat object, such as a board, in the path of the sound beam. Dolby Digital or DTS sources cannot be played back. (Dolby Digital or DTS indicator does not light up in the front panel display.) The connected component is not set to output Dolby Digital or DTS digital signals. The input mode is set to ANALOG. Make an appropriate setting following the operating instructions for your component. Set the input mode to AUTO. There is noise interference when a subwoofer is not connected to this unit. The protection circuitry was in operation because a source with strong bass elements was played back. Turn down the volume level. Select SUBWOOFER for BASS OUT. Connect a subwoofer and adjust settings for SUBWOOFER SET. Low-frequency sounds are distorted. CROSS OVER in SUBWOOFER SET is set Set CROSS OVER correctly. incorrectly. On-screen display does not appear. The OSD video pin cable is not connected properly. Connect the cable properly. This unit does not operate properly. The internal microcomputer has been frozen by an external electric shock (such as lightning or excessive static electricity) or by a power supply with low voltage. Disconnect the AC power supply cable from the outlet and plug it in again after about 30 seconds. No sound is heard from the TV connected via HDMI. The TV does not accept the multi-channel audio signals. Convert the multi-channel audio signals to the 2-channel audio signals at the source component such as a DVD player. "SUPPORT AUDIO" is set to "YSP-3050". Set "SUPPORT AUDIO" to "OTHER". There is noise interference from digital or highfrequency equipment. This unit is too close to the digital or high- Move this unit farther away from such frequency equipment. equipment. This unit does not output effect sounds properly. The original source includes surround effects. Disable the surround effect settings of this unit. My Beam auto-adjust function does not work. The listening room is too noisy. Keep the listening room as quiet as possible. Try manual-adjust function. The sound reflectivity of the listening room Set REFLECTING to HI ECHO. is too much. The remote control may be operated outside of the remote control operation range. The remote control functions within a maximum range of 6 m (20 ft) and no more than 45 degrees off-axis from the front panel. The function does not work properly because of the condition of the connected components. Select My Beam and then try again. See page 80 80 69 81 - - - - 90 41 80 80 80 18 - - 84 - - - 64 81 24 63 ADDITIONAL INFORMATION English 101 En