Yamaha YST-SW325 Owner's Manual - Page 12

CONNECTIONS Connecting to the INPUT1/OUTPUT terminals of the subwoofer ■ Before connecting Remove the insulation coating at the extremity of each speaker cable by twisting the coating off. Good 10mm (3/8") No Good Plug in the subwoofer to the AC outlet After all connections are completed, plug in the subwoofer and other audio/video components to the AC outlet. OUTPUT TO SPEAKERS INPUT 1 FROM AMPLIFIER INPUT PHASE 2 L /MONO NORM REV R AUTO STANDBY HIGH LOW OFF VOLTAGE SELECTOR 220V-240V 110V-120V POWER ON OFF ■ How to connect 1 Press and hold the terminal's tab, as shown in the figure below. 2 Insert the bare wires. 3 Release your finger from the tab to allow it to lock securely on the cable's wire end. 4 Test the firmness of the connection by pulling lightly on the cable at the terminal. + To AC outlet 1 2 - Notes • Do not let the bare speaker wires touch each other, because this could damage the subwoofer or the amplifier, or both of them. • For connection, keep the speaker cables as short as possible. Do not bundle or roll up the excess part of the cables. If the connections are faulty, no sound will be heard from the subwoofer or the speakers, or both of them. • Make sure that the + and - polarity markings of the speaker terminals are observed and set correctly. If these cables are reversed, the sound will be unnatural and lack bass. 8