Zanussi Z816WT85BI User Manual - Page 10

min. 1.6 must be larger than the external diameter

Get Zanussi Z816WT85BI PDF manuals and user guides View all Zanussi Z816WT85BI manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

5. Connect the water inlet hose to the cold water tap with 3/4 thread. WARNING! Make sure that there are no leaks from the couplings. Use the hose supplied with appliance. Do not use an extension hose if the inlet hose is too short. Contact the Authorised Service Centre for an inlet hose replacement. Water drainage The drain hose can be connected: Ø 40 mm To a stand pipe with vent-hole Directly into a drain pipe at a height of not less than 60 cm (23.6") and not more than 100 cm (39.3"). The end of the drain hose must always be ventilated , i.e. the inner diameter of the drain pipe (min. 40 mm min. 1.6") must be larger than the external diameter of the drain hose. To a sink spigot Put the drain hose in the spigot and tighten it with the supplied cable tie L. Make sure that the drain hose makes a loop to prevent particles going into the appliance from the sink. max.600 mm 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
5.
Connect the water inlet hose to the cold water tap
with 3/4 thread.
WARNING!
Make sure that there are no
leaks from the couplings.
Use the hose supplied with appliance.
Do not use an extension hose if the inlet hose is too short. Contact the Authorised Service
Centre for an inlet hose replacement.
Water drainage
The drain hose can be connected:
Ø 40 mm
To a stand pipe with vent-hole
Directly into a drain pipe at a height of not less than
60 cm (23.6”) and not more than 100 cm (39.3”).
The end of the drain hose must always be ventilated ,
i.e. the inner diameter of the drain pipe (min. 40 mm -
min. 1.6”) must be larger than the external diameter
of the drain hose.
max.
600 mm
To a sink spigot
Put the drain hose in the spigot and tighten it with
the supplied cable tie
L
.
Make sure that the drain hose makes a loop to pre-
vent particles going into the appliance from the sink.
10