Zenith SL-5797-NB-C User Guide - Page 1

DualBrite® Motion Sensor Light Control Model 5797 Requirements • The light control requires 120-volts AC. • If you want to use Manual Mode, the control must be wired through a switch. • Some codes require installation by a qualified electrician. • This product is intended for use with the enclosed gasket and with a junction box marked for use in wet locations. Meets the ENERGY STAR® guidelines when DualBrite® function is off and ON-TIME is 1 or 5 minutes. Features • Turns on lighting when motion is detected. • Automatically turns lighting off. • Three lamp modes available: Normal, Soft, or Flash. • DualBrite® Timer. • Photocell keeps the lighting off during daylight hours. • LED indicates motion was sensed (day or night). This package includes: Rubber Plug Plastic Hanger 6 Mounting Screws (3 sizes) OPERATION Mode: Test Normal Manual Accent On-Time: Works: Day Night 5 Sec x x 1, 5, 20 min. x Until Dawn* x 3, 6 Hr. to Dawn x * resets to Auto Mode at dawn. Note: When first turned on wait about 1 1/2 minutes for the circuitry to calibrate. TEST Put ON-TIME switch on the sensor bottom to TEST and the DualBrite® switch OFF. ON-TIME TEST 1 5 20 DualBrite® Off 3 6 Dusk to Dawn LAMP MODE Put the LAMP MODE switch in the Normal, Soft, or Flash position. LAMP MODE NORMAL SOFT FLASH Cover Plate Sensor Light Control 2 Wire Connectors AUTO Put the ON-TIME switch in the 1, 5, or 20 minute position. Mounting Bolt Mounting Strap Gasket ON-TIME TEST 1 5 20 2 Halogen Bulbs (Installed) Light Shield © 2007 HeathCo LLC 598-1315-02