Zenith SL-6053-WH User Guide - Page 7

ENGLISH Receiver Information All receivers have the following features and ratings: • Rated for 120VAC/60Hz supply voltage. • Uses existing wiring. • Fits standard single gang junction box (wall switch only). • Not for use with Compact Fluorescent bulbs. • When first turned on wait 15 seconds. Wall Switch Receiver Features and Ratings: • Up to 500 Watt maximum incandescent load depend- ing upon switch purchased. See rating label on switch for exact load rating. • Not for use with Compact Fluorescent bulbs. WARNING: FOR USE ONLY with 120 volt incandescent or halogen bulbs. CAUTION: To reduce the risk of overheating and possible damage to other equipment, do not install to control a receptacle, a motor-operated appliance, a fluorescent lighting fixture, or a transformer-supplied appliance. 4. If necessary, strip away 1/2" of insulation from end of wires. 5. Connect one of the black power wires from receiver to one of the power wires you removed from the old switch. Use one of the supplied wire connectors to secure the wires (see illustration). 6. Connect the second black power wire from receiver to the other power wire you removed from the old switch. Use one of the supplied wire connectors to secure the wires (see illustration). 7. Connect the green ground wire from receiver to the ground wire removed from old switch. Use one of the supplied wire connectors to secure the wires (see illustration). 8. Check wire connections to make sure they are secure and that no bare wires are exposed. 9. Route antenna between the bottom of the junction box and the wall. Feed antenna into wall cavity while placing wall switch into junction box. 10. Position the wall switch receiver in the junction box with the DIM button located to the right. Use the two wall switch screws (long) supplied to mount the receiver to the wall box (see illustration). Push excess wiring into wall box while you do this. You may need to bend the wires to fit inside the box. Mount wall plate on wall switch receiver with screws (short) provided. 11. Turn on the power to the light switch circuit. Do this at your circuit breaker or fuse box. Important: When ganging these units, they must be derated as follows: Gang 300 W 500 W 1 300 W 500 W 2 300 W 475 W 3 300 W 450 W Installation 1. Select light switch to be replaced by wall switch receiver. 2. WARNING: Turn off the power to the light switch circuit before you proceed. Do this at your circuit breaker or fuse box. 3. Remove the existing wall plate and switch. Disconnect the two power wires and the ground wire. Note: If there are more than two power wires attached to the switch, consult an electrician about installation. In addition, some local build- ing codes may require installation by a qualified electrician. CAUTION: Do not connect neutral (white wire) to switch. Ground Wire (Bare or Green) Wall ON/OFF Button Switch Junction Box Wall Switch Screw Wall Plate Screw White (Neutral) Wall Wall Plate Antenna DIM Button Power Disconnect Switch Installing Wall Switch Receiver 598-1306-04