ZyXEL G-4100 v2 User Guide - Page 3

Rear Panel, Yellow LED: 100 Mbps Link/ACT. This LED comes on when there is a 100 Mbps connection - ip

Get ZyXEL G-4100 v2 PDF manuals and user guides View all ZyXEL G-4100 v2 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 3 highlights

2.2 Rear Panel 1 Reset button 2 Power switch 3 DC power socket 4 Ethernet port (RJ-45) 5 PS/2 keypad port SP-200E User's Start Guide 1 23 4 5 Table 1 Rear Panel Hardware Label Description RST ON OFF Press this button for 10 seconds to restore the factory default settings. The default IP address is 192.168.1.1. Use this power switch to turn the printer on or off. DC POE RJ-45 port PS/2 keypad port Use the printer's included power adaptor to connect this power socket to a power supply. Use an Ethernet cable to connect this port to the gateway. You can use a mid-span POE (Power Over Ethernet) injector (not included) instead of the power adaptor. Yellow LED: 100 Mbps Link/ACT. This LED comes on when there is a 100 Mbps connection and blinks when sending or receiving traffic. Green LED: 10 Mbps Link/ACT, green. This LED comes on when there is a 10 Mbps connection and blinks when sending or receiving traffic. Connect an optional PS/2 keypad to this port. Refer to the hotspot gateway User's Guide for information on how to configure the gateway for use with the SP-200E and the optional PS/ 2 keypad. 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
SP-200E User’s Start Guide
3
Table 1
Rear Panel Hardware
2.2 Rear Panel
1
Reset button
2
Power switch
3
DC power socket
4
Ethernet port (RJ-45)
5
PS/2 keypad port
Label
Description
RST
Press this button for 10 seconds to restore the factory default settings. The default IP
address is 192.168.1.1.
ON OFF
Use this power switch to turn the printer on or off.
DC
Use the printer’s included power adaptor to connect this power socket to a power supply.
POE RJ-45 port
Use an Ethernet cable to connect this port to the gateway. You can use a mid-span POE
(Power Over Ethernet) injector (not included) instead of the power adaptor.
Yellow LED: 100 Mbps Link/ACT. This LED comes on when there is a 100 Mbps connection
and blinks when sending or receiving traffic.
Green LED: 10 Mbps Link/ACT, green. This LED comes on when there is a 10 Mbps
connection and blinks when sending or receiving traffic.
PS/2 keypad port
Connect an optional PS/2 keypad to this port. Refer to the hotspot gateway User’s Guide for
information on how to configure the gateway for use with the SP-200E and the optional PS/
2 keypad.
1
2
3
4
5