eMachines G630 Service Guide - Page 41
WinFlash Utility, Please do not remove AC Power Source, Flash programming complete
View all eMachines G630 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
4. In flash BIOS, the message Please do not remove AC Power Source displays. Plug in the AC power to continue. 5. Flash is complete when the message Flash programming complete displays. WinFlash Utility Perform the following steps to use the WinFlash Utility: 1. Double-click the WinFlash executable. 2. Click OK to begin the update. WinFlash closes all applications and shuts down the system. NOTE: Place only one *.wph file with flash32.exe in the same folder when executing this procedure. Chapter 2 31
Chapter 2
31
4.
In flash BIOS, the message
Please do not remove AC Power Source
displays.
Plug in the AC power to continue.
5.
Flash is complete when the message
Flash programming complete
displays.
WinFlash Utility
Perform the following steps to use the WinFlash Utility:
1.
Double-click the WinFlash executable.
2.
Click
OK
to begin the update. WinFlash closes all applications and shuts down the system.
NOTE:
Place only one
*.wph
file with flash32.exe in the same folder when executing this procedure.