2006 BMW M3 Owner's Manual - Page 139
2006 BMW M3 Manual
Page 139 highlights
Tire repair with the M Mobility system Using the M Mobility system To repair a flat tire using the M Mobility system, proceed as follows: > Fill with sealant, refer to page 139 > Distribute the sealant, refer to page 139 > Restore tire inflation pressure, refer to page 139. 139 8. With the ignition key in position 2: Switch on the compressor and keep it running for approx. 3 minutes to fill in the sealant. It does not matter what the tire's inflation pressure is afterward 9. Turn the system off and disconnect the hose from the sealant bottle and the wheel valve. Stow the M Mobility system in the vehicle. Filling with sealant 1. Shake the bottle of sealant 2. Screw hose 9 onto the opening of the sealant bottle 3. Twist the dust cap off of the valve on the flat tire and screw filler hose 2 connected to the sealant bottle onto the valve 4. Insert the sealant bottle into the connector on the compressor so that it is standing upright 5. Make sure that the system is switched off, position 0 6. Insert connector 3 into the cigarette lighter socket inside the vehicle, refer to page 98 7. When using the version with the manometer on the hose: make sure that screw 8 on the pressure gauge is tightened down Right afterward, drive at least about 2 miles / 3 km, so that the sealant is distributed evenly in the tire. Do not exceed a maximum speed of 35 mph / 60 km/h. If possible, keep the vehicle speed above 12 mph / 20 km/h.< Inflating tire to correct pressure 1. After driving approx. 1.9 miles/3 km, pull over at a suitable location 2. Screw hose 9 connected to the compressor directly onto the tire valve 3. Insert connector 3 into the cigarette lighter socket inside the vehicle Online Edition for Part-No. 01 41 0 158 512 - © 09/04 BMW AG Index Data Repairs Maintenance Distributing the sealant Controls Overview