2006 BMW X3 Owner's Manual - Page 103
2006 BMW X3 Manual
Page 103 highlights
bracket. To do so, loosen the bolt, refer to arrow, and place the reservoir to one side. Bear in mind that the windshield washing system reservoir is heavy. If you do not, injuries or damage to the vehicle can occur.< For bulb replacement procedure, refer to Driver's side. Front passenger side Before replacing the bulb, remove the reservoir of the windshield washer system from the bracket, refer to Halogen low beams on page 100. For bulb replacement procedure, refer to Driver's side. Halogen high beams H7 bulb, 55 watts Always wear gloves and eye protection - the atmosphere within the bulb is pressurized. Failure to observe this precaution can lead to personal injury should the bulb be damaged.< For checking and adjusting headlamp aim, please contact your BMW Sports Activity Vehicle Center.< Turn signal, front 21 watt bulb Driver's side 1. Open the clip and remove the lamp cover. Access to the turn signal is at the edge of the lamp unit, refer to arrow. Make sure that the lamp base does not fall into the engine compartment; otherwise, the vehicle can be damaged or other road users can be endangered.< 1. Turn the lamp base and remove it. 2. Replace the bulb. 3. Insert the lamp base. If it does not snap into place immediately, turn the lamp base until it does. 2. Press the bulb holder downward and remove, refer to Low beams. 3. Pull off the lamp base; plug in a new lamp base. 4. Place the lamp base with the lower edge against the bracket and press it in until the lamp base locks into place. Make sure that the cover does not fall into the engine compartment; otherwise, the vehicle can be damaged or other road users can be endangered.< Side-mounted turn signals 5 Watt bulb Mobility Reference 1. Use finger pressure against the rear end of the lamp, refer to arrow, to press it forward for removal. 101 Online Edition for Part No. 01 41 0 012 213 - © 02/06 BMW AG Driving tips Controls At a glance