2007 BMW 7 Series Owner's Manual - Page 114
2007 BMW 7 Series Manual
Page 114 highlights
Practical interior accessories The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter. You can operate the system when the engine is running or when the ignition is switched on. If the device cannot be used after repeated programming, check whether the original hand-held transmitter uses an alternating-code system. To do so, either read the instructions of the original hand-held transmitter or press and hold down the programmed memory button 1 of the integrated universal remote control. If the LED 2 on the integrated universal remote control flashes rapidly for a short time and then remains lit for approx. 2 seconds, then this indicates that the original hand-held transmitter is equipped with an alternating-code system. In the case of an alternating-code system, program the memory buttons 1 as described in the Alternating-code hand-held transmitters section below.< 5. Press the programmable memory button 1 on the integrated universal remote control three times. The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter. If you have any additional questions, please contact your BMW center.< Deleting stored programs Press the left and right memory buttons 1 for approx. 20 seconds until the LED 2 flashes rapidly: All stored programs are deleted. It is not possible to delete individual programs. Roller sun blinds* Rear window blind Alternating-code hand-held transmitters Consult the operating instructions of the unit you wish to set when programming the universal remote control. You will find information there on the possibilities for synchronization. When programming hand-held transmitters that employ an alternating code, please follow the supplementary instructions below: Programming will be easier with the aid of a second person.< 1. Park your vehicle within the range of the remote-controlled device. 2. Program the integrated universal remote control as described above in the Fixedcode hand-held transmitters section. 3. Locate the button on the receiver of the device you want to set up, e.g. on the upper section of its drive unit. 4. Press the button on the receiver of the device you want to set up. After step 4, you have approx. 30 seconds for step 5. Briefly press the button on the driver's door with the ignition in radio ready state or higher. Roller sun blinds for rear side windows 1 2 3 Quarter window blind Side window blind Rear window blind 112 Online Edition for Part no. 01 41 0 013 316 - © 02/07 BMW AG