2010 BMW 128 Owner's Manual - Page 110
2010 BMW 128 Manual
Page 110 highlights
Things to remember when driving Things to remember when driving Break-in period Moving parts need breaking-in time to adjust to each other. Please follow the instructions below in order to achieve the optimal service life and economy of operation for your vehicle. Following part replacement The same break-in procedures should be observed if any of the components mentioned above have to be renewed in the course of the vehicle's operating life. Engine and differential Always obey all official speed limits. Saving fuel The fuel consumption of your vehicle depends on several factors. You can lower fuel consumption and the environmental impact by taking certain measures, adjusting your driving style and having the vehicle serviced regularly. Up to 1,200 miles/2,000 km Drive at varying engine and road speeds, but do not exceed an engine speed of 4,500 rpm or a road speed of 100 mph/160 km/h. Avoid full-throttle operation and use of the transmission's kickdown mode. Remove any unneeded cargo Additional weight increases fuel consumption. After driving 1,200 miles/2,000 km Engine and vehicle speeds can be gradually increased. Remove any mounted parts after you have finished using them Remove unneeded additional mirrors, the roof rack and the rear luggage rack after use. Mounted parts affect the vehicle's aerodynamics and increase fuel consumption. Tires Due to technical factors associated with their manufacture, tires do not achieve their full traction potential until after an initial break-in period. Therefore, drive cautiously during the first 200 miles/300 km. Close the windows and glass roof An open glass roof or window causes higher air resistance and thus increases fuel consumption. Brake system Brakes require an initial break-in period of approx. 300 miles/500 km to achieve optimized contact and wear patterns between brake pads and rotors. Drive cautiously during this break-in period. Check tire inflation pressure regularly Check the tire inflation pressure at least twice a month and before embarking on a long journey, and correct it if necessary. Low tire inflation pressure causes higher rolling resistance and thus increases fuel consumption and tire wear. Clutch The function of the clutch reaches its optimal level only after a distance driven of approx. 300 miles/500 km. During this break-in period, engage the clutch gently. Set off immediately Do not let the engine warm up while the car is still standing, but set off immediately at moderate engine speed. This is the fastest way for the cold engine to reach its operating temperature. 108 Online Edition for Part no. 01 41 2 602 846 - © 08/09 BMW AG