2010 BMW 128 Owner's Manual - Page 89

3. "Welcome light" Activating/deactivating daytime running lights 1. "Settings" 2. "Lighting" 3. "Daytime running lamps" Welcome lamps are activated and are stored for the remote control currently in use. Pathway lighting If you activate the headlamp flasher after switching off the ignition with the lamps switched off, the low beams come on and remain on for a certain time. Daytime running lights are activated and are stored for the remote control currently in use. Setting the duration or deactivating 1. "Settings" 2. "Lighting" 3. "Pathway light.:" 4. Set a time of duration, or 0 s to deactivate the function. Adaptive light control* The concept Adaptive light control is a variable headlamp control system that enables better illumination of the road surface. Depending on the steering angle and other parameters, the light from the headlamp follows the course of the road. In tight curves at speeds up to 40 mph/70 km/h, e.g. on mountainous roads or when turning, an additional, corner-illuminating lamp is switched on that lights up the inside area of the curve. Activating adaptive light control The setting is stored for the remote control currently in use. With the ignition switched on, turn the light switch to position 3, refer to page 86. The corner-illuminating lamp is switched on automatically, depending on the steering wheel angle or turn signal indicator. Standstill function*: to avoid blinding oncoming traffic, the adaptive light control directs light towards the front passenger side when the vehicle is at a standstill. When you are reversing, only the corner-illuminating lamps are active and switched on on both sides. 87 Online Edition for Part no. 01 41 2 602 846 - © 08/09 BMW AG Daytime running lights The daytime running lights light up in switch position 0, 1 and 3. They are less powerful than the low beams. Reference Mobility Communications Entertainment Navigation Driving tips Controls At a glance