2010 BMW 135 Owner's Manual - Page 39

with Comfort Access, refer to Locking on page 33. 1. Unclip the front of the cover of the interior lamps using the screwdriver from the onboard vehicle tool kit, refer to page 209. After switching off the ignition When the remote control is removed or the ignition is switched off, you can still operate the roof for approx. 1 minute as long as no door has been opened. Pinch protection system If the glass roof encounters an obstruction during closing from approximately the middle of the opening in the roof, or during closing from the raised position, the closing movement is interrupted and the glass roof is opened again slightly. Despite the pinch protection system check and clear the roof's travel path prior to closing it; otherwise, the safety system might fail to detect certain kinds of obstructions, such as very thin objects, and the roof would continue closing.< Closing without pinch protection If there is an external danger, press the switch forward past the resistance point and hold it there. The roof closes without pinch protection. 3. Remove the control unit. 4. Unplug the motor. Considerably less effort will be required for manual operation. Following interruptions in electrical power supply After a power failure, there is a possibility that the glass roof can only be raised. The system must be initialized. BMW recommends having this work done by your BMW center. Closing manually* In the event of an electrical malfunction, you can move the glass roof manually: 5. Insert the Allen wrench* supplied with the onboard vehicle tool kit, refer to page 209, 37 Online Edition for Part no. 01 41 2 602 846 - © 08/09 BMW AG Reference Mobility Communications Entertainment Navigation Driving tips 2. On both sides, use the screwdriver to press on the clip inside the opening. Controls At a glance