1998 Cadillac Catera Owner's Manual - Page 159

The cassette tape is broken. (Check to see your if tape is broken. Try a new tape.) SIDE: Press this button change the side the tape to of that is playing. (PLAY shows on the display.) SOURCE: Press this button to select a source. If no cassette tape is in the tape player, CASS appears on the display and then the radio station appears briefly. The display then reverts back to showing the time of Press day. this button again orBAND to switch back to the radio. 4 EJECE Press the upward triangle button to remove a tape. The radio will play. Eject may be activated with the radio off. Cassette tapes may be loaded with the radio off but they will notstart playing until the PWR button is pressed. Press PWR orturn the ignitionoff to stop the cassette tape player. The tape will stay in the player and resume playat the point where it stopped. CLN: If this message appears on the display, the cassette tape player needs to cleaned. It will still play be tapes, but you should clean it soon as possible to as prevent damageto the tapes and player. "Care of See Your Cassette Tape Player" in the Index. After you clean the player, press and hold the eject buttonfive for seconds to reset the CLN indicator. radio will The display --- to show the indicator was reset. Dolby Noise Reductionis manufactured under a license from Dolby Laboratories Licensing Corporation. Dolby and thedouble-D symbol are trademarks Dolby of Laboratories Licensing Corporation. REV: Press the left arrow to rewind the tape rapidly. The radio will play while the tape reverses and REV will appear on the display. You may use your station pushbuttons to tune to another radio station while in REV mode. Press the arrow again to return to left playing speed. FF: Press the right arrow to fast forward to another part of the tape.The radio will play while the tape advances and FF will appear on the display. may use your You station pushbuttons to tune to another radio station while in FF mode. Press the right arrow again to return to playing speed. SEEK-TUNE: Press the right arrow to seek to the next selection on the tape. Press the left arrow to search for the previous selection on the tape (REP will on appear the display).Your tape must have at least three seconds of silence between each selection SEEK-TUNE to for work. The sound will mute while seeking. SCAN: Press this button. SCAN will appear on the FF display untilthe next selectionis found and then SCAN PLAY will appearon the display. Use SCAN to listen to selections for a few seconds. The tape will go to a selection, stop for a few seconds, then on to the next go selection. Press this button again to stop scanning.