2013 Cadillac ATS Owner Manual - Page 114

5-4 Instruments and Controls Wiper Parking If the ignition is put in OFF while the wipers are on LO, HI, or INT, they will immediately stop. If the windshield wiper lever is then moved to OFF before the driver door is opened or within 10 minutes, the wipers will restart and move to the base of the windshield. If the ignition is put in OFF while the wipers are performing wipes due to windshield washing, the wipers continue to run until they reach the base of the windshield. Horn Press a on the steering wheel pad to sound the horn. Windshield Wiper/Washer INT: (Intermittent Wipes): Move the lever up to INT for intermittent wipes, then turn the x INT band up for more frequent wipes or down for less frequent wipes. With the ignition in ACC/ ACCESSORY or ON/RUN/START, move the windshield wiper lever to select the wiper speed. HI: Use for fast wipes. LO: Use for slow wipes. OFF: Use to turn the wipers off. 8 (Mist): For a single wipe, briefly move the wiper lever down. For several wipes, hold the wiper lever down. Clear snow and ice from the wiper blades and windshield before using them. If frozen to the windshield, carefully loosen or thaw them. Damaged blades should be replaced. See Wiper Blade Replacement on page 10‑30. Heavy snow or ice can overload the wiper motor. Rainsense™ For vehicles with Rainsense, a sensor near the top center of the windshield detects the amount of water on the windshield and controls the frequency of the windshield wiper. Keep this area of the windshield clear of debris to allow for best system performance.