2014 Cadillac SRX Owner Manual - Page 315

Vehicle Care The TPMS sensor matching process is: 1. Set the parking brake. 2. Place the vehicle power mode in ON/RUN/START. See Ignition Positions on page 9-15. 3. Make sure the Tire Pressure info display option is turned on. The info displays on the DIC can be turned on and off through the Settings menu. See Driver Information Center (DIC) on page 5-26. 4. Use the five-way DIC control on the right side of the steering wheel to scroll to the Tire Pressure screen under the DIC info page. See Driver Information Center (DIC) on page 5-26. 5. Press and hold the SEL button in the center of the five-way DIC control. The horn sounds twice to signal the receiver is in relearn mode and the TIRE LEARNING ACTIVE message displays on the DIC screen. 6. Start with the driver side front tire. 7. Place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor. A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position. 8. Proceed to the passenger side front tire, and repeat Step 7. 9. Proceed to the passenger side rear tire, and repeat Step 7. 10. Proceed to the driver side rear tire, and repeat Step 7. The horn sounds two times to indicate the sensor identification code has been matched to the driver side rear tire, and the TPMS sensor 10-55 matching process is no longer active. The TIRE LEARNING ACTIVE message on the DIC display screen goes off. 11. Shut the ignition off. 12. Set all four tires to the recommended air pressure level as indicated on the Tire and Loading Information label. Tire Inspection We recommend that the tires, including the spare tire, if the vehicle has one, be inspected for signs of wear or damage at least once a month. Replace the tire if: . The indicators at three or more places around the tire can be seen. There is cord or fabric showing through the tire's rubber. .