2014 Cadillac SRX Owner Manual - Page 34

2-6 Keys, Doors, and Windows passenger seats. The storage area will need to be opened and the storage tray lifted up to access the transmitter pocket. 4. Press the ENGINE START/ STOP button. When the transmitter is learned the DIC display will show that it is ready to program the next transmitter. 5. Remove the transmitter from the transmitter pocket and press the transmitter K or Q button. To program additional transmitters, repeat Steps 3-5. When all additional transmitters are programmed, press and hold the ENGINE START/STOP button for 12 seconds to exit programming mode. Programming without a Recognized Transmitter will take approximately 30 minutes to complete. The vehicle must be off and all of the transmitters you wish to program must be with you. 1. Insert the vehicle key of the transmitter into the key lock cylinder on the driver door handle and turn the key, counterclockwise, to the unlock position five times within 10 seconds. The Driver Information Center (DIC) displays REMOTE LEARN PENDING, PLEASE WAIT. 2. Wait for 10 minutes until the DIC displays PRESS ENGINE START BUTTON TO LEARN and then press the ENGINE START/STOP button. The DIC displays will again show REMOTE LEARN PENDING, PLEASE WAIT. 2. Insert the vehicle key of the transmitter into the key lock cylinder on the driver door handle and turn the key, counterclockwise, to the unlock position five times within 10 seconds. The Driver Information Center (DIC) displays READY FOR REMOTE #2, 3, 4, ETC. 3. Place the new transmitter into the transmitter pocket. The transmitter pocket is inside the center console storage area between the driver and front If there are no currently recognized transmitters available, follow this procedure to program up to eight transmitters. This feature is not available in Canada. This procedure