2014 Cadillac SRX Owner Manual - Page 37

Keys, Doors, and Windows Other conditions can affect the performance of the transmitter. See Remote Keyless Entry (RKE) System on page 2-2 for additional information. Starting the Engine Using Remote Start 1. Press and release RKE transmitter. 3. Press the brake pedal and select the ON/RUN/START ignition mode to drive the vehicle. Extending Engine Run Time The engine run time can also be extended by another 10-minutes, if during the first 10 minutes Steps 1-2 are repeated while the engine is still running. This provides a total of 20 minutes. The remote start can only be extended once. When the remote start is extended, the second 10-minute period is added on to the first 10 minutes for a total of 20 minutes. A maximum of two remote starts, or a remote start with an extension, are allowed between ignition cycles. The vehicle's ignition must be changed to ON/RUN/START and then back to OFF before the remote start procedure can be used again. Shutting the Engine Off After a Remote Start 2-9 To cancel a remote start, do any of the following: . Press and hold / until the parking lamps turn off. Turn on the hazard warning flashers. Turn the vehicle on and then off. Q on the . . 2. Immediately press and hold / for at least four seconds or until the turn signal lamps flash. The turn signal lamps flashing confirms the request to remote start the vehicle has been received. During the remote start the doors will be locked and the parking lamps will remain on as long as the engine is running. The engine will shut off after 10 minutes unless a time extension is done or the ignition is put in ON/RUN/START. Conditions in Which Remote Start Will Not Work The remote start will not operate if any of the following occur: ... The transmitter is in the vehicle. The hood is not closed. The hazard warning flashers are on. There is an emission control system malfunction. The engine coolant temperature is too high. The oil pressure is low. . . .