1998 Chevrolet Astro Owner's Manual - Page 137
1998 Chevrolet Astro Manual
Page 137 highlights
Training a Garage Opener with a "Rolling Code" Feature If you programmed the universal transmitter, but the garage door will not open, and if your garage door opener was manufactured after 1995, your garage door may have a security feature that changes the "code" of your garage door opener every time it is opened or closed. 3. Locate the training button on thegarage door opener receiver. The exact location and color will vary. 4. Press the training button on the garage door opener receiver for one to two seconds. 5 . Return to your vehicle and pressthe programmed button on the universal transmitter until the red light flashes rapidly (about two seconds). To determine if your garage door opener has this "rolling code" feature, press the appropriate button on the universal transmitter that was programmed. If the red light flashes rapidly for one to two seconds, then turns solid, your garage door opener has this feature. To program a garage door opener with the rolling code feature, do the following: 1. Program your hand-held transmitter to the universal transmitter by following the steps provided under "Programming the Transmitter" earlier in this section. 2. Remove the cover panel from the garage door opener receiver. It is located near thegarage door opener motor. 6. Release the button, then press the button again to confirm that it was programmedto the garage door opener receiver. You may now use either the universal transmitter or the hand-held transmitter to open your garage door. If you still have difficulty in programming and require assistance, please call 1-800-355-35 15, Accessories Accessories for the universal transmitter are available from the manufacturer of the unit. If you would like additional information, please call 1-800-355-35 15. 2-53