2005 Chevrolet Cobalt Owner's Manual - Page 145
2005 Chevrolet Cobalt Manual
Page 145 highlights
DISP (Display): Press this knob to switch the display between the time radio station frequency. When the ignition is off, press this knob to display the time. To change the default on the display, press the DISP knob until you see the display you want, then hold the knob for two seconds. The radio will produce a beep and the selected display will now be the default. Setting Preset Stations Up to 18 stations (six FM1, six FM2, and six AM), can be programmed on the six numbered pushbuttons, by performing the following steps: 1. Turn the radio on. 2. Press BAND to select FM1, FM2, or AM. 3. Tune in the desired station. 4. Press and hold one of the six numbered pushbuttons until you hear a beep. Whenever that numbered pushbutton is pressed, the station that was set will return. 5. Repeat the steps for each pushbutton. Finding a Station BAND: Press this button to switch between FM1, FM2, and AM. The display will show the selection. ADJ (Adjust): Turn this knob to select radio stations. © SEEK ¨: Press the right or left arrow to go to the next or to the previous station and stay there. To scan stations, press and hold either arrow for two seconds until you hear a beep. The radio will go to a station, play for a few seconds, then go on to the next station. Press either arrow again to stop scanning. To scan preset stations, press and hold either arrow for more than four seconds until you hear two beeps. The radio will go to the first preset station stored on the pushbuttons, play for a few seconds, then go on to the next preset station. Press either arrow again to stop scanning presets. The radio will only seek and scan stations with a strong signal that are in the selected band. Setting the Tone (Bass/Treble) EQ (Tone): To adjust the bass or the treble, press and release the EQ button until BASS or TREB appears on the display. Turn the ADJ knob to increase or to decrease. The display will show the bass or treble level. If a station is weak or noisy, decrease the treble. To adjust bass or treble to the middle position, select BASS or TREB. Then press and hold the EQ button for more than two seconds. You will hear a beep and the level will be adjusted to the middle position. 3-47