2010 Chevrolet Cobalt Owner's Manual - Page 152

x (Delay) : Move the lever to the & position, then turn the x band up for more frequent wipes or down for less frequent wipes. 6 (Low Speed) : Slow wipes. 1 (High Speed) : Fast wipes. 8 (Mist) : Single wipe, move the lever down, then release it. Several wipes, hold the lever down. Clear ice and snow from the wiper blades before using them. If frozen to the windshield, carefully loosen or thaw them. Damaged wiper blades should be replaced. Heavy snow or ice can overload the wiper motor. A circuit breaker stops the motor until it cools. If the motor gets stuck, turn the wipers off, clear away the snow or ice, and then turn the wipers back on. As an added safety feature, if the wipers are on for more than 15 seconds, the vehicle's headlamps turn on automatically. They turn off 15 seconds after the wipers are turned off. Windshield Washer Press the button at the end of the windshield wiper lever until the washers begin. { WARNING: In freezing weather, do not use your washer until the windshield is warmed. Otherwise the washer fluid can form ice on the windshield, blocking your vision. When the button is released, the washers stop, but the wipers continue to wipe about three times or resume the previous speed. Cruise Control With cruise control, a speed of about 40 km/h (25 mph) or more can be maintained without keeping your foot on the accelerator. Cruise control does not work at speeds below 40 km/h (25 mph). The brake must be applied at least one time, after the vehicle has been started, before cruise control will function. 4-6